Intalling An Over-Under Kit To Flip the Axle On Weekend Warrier Trailer

Question

Question:

Hi I have an 07 3105 week end warrior. I am making axle a top mount But their are no top plates on the top of axle do i need to weld some on?

asked by: Raymond J

0

Expert Reply:

When using an Over-Under Kit like the Dexter Trailer Springs Over-Under Conversion Kit for 2-3/8 inch axles # K71-384-00 or # K71-385-00 for 3 inch axles it is recommended to install a spring seat on the opposite side of the axle or at least tack weld the plate.

expert reply by: Jason S

0

Answer 1

To convert your axle for a top mounted leaf spring I would recommend replacing the U bolts, nuts and tie plates, so your best bet would be to go with a U bolt kit. For a 2-3/8" round axle use #APUBR-1 For a 3" round axle use #APUBR-9 You…

view full answer...

Answer 2

We offer two versions of the Dexter Axle Over-Under Conversion kit, often called a flip kit, that are to be selected based on the diameter of the trailer's axles. Kit #K71-384-00 works with 2-3/8-inch diameter axles and kit #K71-385-00 works on…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Intalling An Over-Under Kit To Flip the Axle On Weekend Warrier Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching