Inside Diameter of Yakima Replacement SuperCush Cradle and ZipStrip 8880597

Question

Question:

What size diameter rack arm does this cradle slide onto?

asked by: Tweakerman

1

Helpful Expert Reply:

The Yakima Replacement SuperCush Cradle and ZipStrip # 8880597 fits on 1-1/8-inch bike rack arm tubing as found on a wide range of Yakima racks, including their Fullback racks # Y02633 and # Y02634, among others.

expert reply by: Adam R

1

Answer 1

The Replacement SuperCush Cradle #8880597 and the Replacement ZipStrip with Anti-Sway Cradle #Y43KV are made specifically for the Yakima brand bike racks. They are both designed to fit on a 1-5/16" round tube. We do not carry the Allen brand…

view full answer...

Answer 2

The Replacement T3 Cradle Body for Thule Bike Carriers #853-5829 and the Replacement Rubber Strap for Thule T3 Bike Carrier Cradles #753-3535 will most likely stretch to fit your 1-1/8 inch bars. However, I reached out to my contact at Thule and they…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Inside Diameter of Yakima Replacement SuperCush Cradle and ZipStrip 8880597

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching