Will Draw-Tite Trailer hitch 41001 Fit a 1986 Chevrolet C-20 Silverado With a Spare Tire
Updated 11/15/2010 | Published 11/14/2010 >
Products Featured in This Question
Question:
need hitch to fit 1986 Chevy c20 Silverado 2-wheel drive with 8 ft. bed with spare tire mounted in back- wanted to make sure hitch shown would fit my truck before i order
asked by: Steve S
Expert Reply:
Draw-Tite hitch # 41001 should work well on your 1986 Chevrolet Silverado, but you would need to either modify the spare tire hanger or relocate the spare tire in order for the hitch to fit.
In addition to the trailer hitch, you would also need a ball mount, hitch ball, hitch pin, and wiring to complete your towing setup. The recommended ball mount for your application would be part # 2753, but to determine whether this would work for your particular trailer, you will need to take some measurements. Measure from the ground to a point just below your bumper, where the hitch would sit. Then, measure from the ground to the flat bottom of the trailer coupler. The difference between these two measurements would be your required rise or drop.
You could use a hitch lock like part # e98882 to secure the ballmount. This lock is stainless steel, so it stands up well to the elements. The most common hitch ball would have a 2 inch diameter, like part # 19247.
To wire your truck for towing, you could use custom fit wiring harness # HM41115, which plugs into factory connectors near the inner end of your driver side frame rail. This would equip the vehicle with a standard 4-Way flat plug.
I am including links to the installation instructions for both models and the wiring, so you can compare, as well as to some additional information on towing and hitch installation in general.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Search Results: trailer hitch wiring harness
- Search Results: trailer hitch wiring custom fit vehicle wiring
- Shop: Brake Controller
- Shop: Trailer Wiring
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Curt 3-Piece Trailer Hitch Receiver - Multi Fit - Class V - 2"
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Q&A: Class V Hitch for 2003 GMC Savanah Cutaway
- Q&A: Curt Trailer Hitch Receiver # C14082 Tube Height From Mounting Flange For 1973 Ford F-100
- Q&A: Trailer Hitch for a 1979 Chevy C-10 with Trailering Special Package
- Q&A: Distance from Mounting Bracket to Top of Receiver on Curt Trailer Hitch # C14082
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: 1990 Chevy C1500 Truck Frame Spacing to Fit Curt Trailer Hitch Receiver
- Q&A: Trailer Hitch Receiver and Wiring Harness For a 1972 Chevrolet K-20 Pickup With Step Bumper
- Shop: Buyers Products 2" Hitch Receiver For GM Express/Savana


