Is Drilling into Frame Required for Installation of the Curt Class III Trailer Hitch on 2003 BMW X5
Updated 10/11/2010 | Published 10/10/2010
Question:
does the Curt Trailer Hitch for a 2003 BMW X5 require drilling of any holes in the car frame? The picture shows 8 bolts.
asked by: grant m
0
Expert Reply:
Yes, the installation of the Curt Trailer Hitch, item # C13162, on the 2003 BMW X5 does require some drilling. You will need to drill and enlarge a hole for installation. I have included a link to the installation instructions to the right for you.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Diagram for Wiring the 2006 BMW X5 Trailer Wiring Harness
- Q&A: Replacement Fender for Single Axle Escort Boat Trailer
- Q&A: What Determines Cargo Weight Limit for Hitch Carrier Installed on RV Bumper Hitch
- Q&A: Curt 13703 Hitch Dimensions from Frame Bracket to Hitch Opening
- Q&A: Need Nut And Bolt For Installing Trailer Hitch On A 2002 BMW X5
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Fan-Tastic Vent LF8000 For Travel Trailer