Replacement Axle for 2,000 Pound Dexter Axle on a Pop-Up Camper
Updated 03/16/2016 | Published 03/15/2016 >
Products Featured in This Question
Question:
my popup trailer axles is multi-bended due to hard... the nameplate is the following exacly: 2000 lbs max cap ser no. c mod 2000 tr 12.0 exce rims and tires dexter axle 1890286 this is the best transcription I can give you dimensions are: 72inch overall lengh, 53inch spring center, 60.5inch brake plate center tube is 1.75inch dia, brake size 7 can you propose a replacement part if you can provide thanks a lot!!!!!!!!!!!!!!!!!!
asked by: Jonathan W
Expert Reply:
We have straight axles that are close to the measurements you have provided, see link, but the spring seats would have to be moved and none of them have brake mounting flanges. I propose a different approach by using a Timbren axle-less system # ASR2KHDS01.
This system will provide the "axle" as well as the suspension in one unit plus the suspension part will not wear out nearly as quickly as traditional leaf springs because the rubber won't corrode. They are also set up for electric brakes.
The spindles on this set up take hubs that use inner bearing L68149 and outer bearing L44649. If the hubs you have do not take these bearings we have several options that will work:
For a 5 on 5 bolt pattern use # AKHD-550-35-EZ-K
For a 5 on 4-1/2 bolt pattern use # AKHD-545-35-EZ-K
For a 5 on 4-3/4 bolt pattern use # AKHD-5475-35-EZ-K
For a 5 on 5-1/2 bolt pattern use # AKHD-555-35-EZ-K
For a 6 on 5-1/2 bolt pattern use # AKHD-655-35-EZ-K
For brakes for any of the above drums I recommend etrailer brakes # AKEBRK-35L and # AKEBRK-35R. I have linked a video review of these brakes for you.
If you want a straight axle that fits your specs then you would have to special order one from a local tractor or trailer supply store.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with Standard Spindles - 72" Long - 2,000 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 2000 lbs
- Spindles Only
- 58 Inch Spring Center
- 72 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Upgraded Equalizer Can I Use to Replace My 5 5/8" Long Standard Equalizer?
- Article: How to Measure a Trailer Axle
- Q&A: What is The Proper Way To Measure A Trailer Fender?
- Q&A: How to Adjust the Height of a 5th Wheel Trailer Pin Box
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: Replacement for 3,500 lb Axle With 92-1/2 Inch Hub Face Measurement
- Q&A: Can Tire Chains be Used with a 2024 Toyota Rav4 Prime With 235/55/R19 Tires
- Q&A: How To Install Lippert Outriggers To Your RV To Install New Pull Out Steps
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: How to Raise Your Travel Trailer Height
- Article: Boat Trailer Guides: Which are the Best?
- Article: How to Measure a Boat Trailer Axle
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams




