Brake Controller Installation on 2014 Dodge Durango

Updated 08/17/2015 | Published 08/16/2015

Products Featured in This Question

Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional

(6644)

$156.98

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(188)

$69.15

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3398)

$121.17

Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers

(66)

$13.94

Question:

does the p3 controller work on 2014 dodge Durango and are every thing needed comes with controller , ready to install, thanks

asked by: Paul B

Expert Reply:

If your 2014 Durango is equipped with the factory 7-way trailer connector at the rear bumper, the installation will be simple. All you'll need is the # 90195 Tekonsha P3 brake controller you mentioned and the # TK93VR brake controller wiring adapter. The adapter would plug into the connector located under the dash, near the top of the emergency brake pedal. The other end of the adapter harness would plug into the rear of the brake controller. The controller would be mounted under the dash, usually to the right of the steering column so it's within easy reach of the driver.

If your vehicle doesn't have the 7-way trailer connector, the install will still be doable, just a little more involved.

For starters, you'll need to install a functioning 4-pole trailer wiring harness, if you don't already have one. I'd recommend using part # 118617, I've linked you to the installation instructions and an installation video. Once the 4-pole connector is installed, you can complete the installation using our Brake Controller Install Kit, part # ETBC7. I'll link you to install details as well as some FAQ articles that will help you through the installation.

expert reply by: Mike L