Bunk Board Guide On Installation Instructions
Updated 06/15/2015 | Published 06/13/2015
Question:
Installing CE 24inch bunk board guide ons. Single axle trailer. 16foot tri hull boat. Question - How close to the boat hull should I set the bunk board ? touching the hull, 1/2 inch away. ..... other ?
asked by: John
Expert Reply:
You will want to give the boat a little wiggle room between the guide-ons. They are there mainly to help you keep you on track as you approach the trailer. The actual bunks of the trailer will center the boat on the trailer once it gets far enough on the trailer. Think of these as a way to pre-center the boat on the trailer as it slides on.
I would go with a couple inches of space between the boat and the bunks. I attached an install video for this product for you to check out as well.
Product Page this Question was Asked From
CE Smith Bunk-Style Guide-Ons for Boat Trailers - 24" Long - 1 Pair
- Boat Trailer Parts
- Guides
- Bunk-Style Guide
- 24 Inch Long
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways - 3 Steps
- Search Results: rv steps
- Shop: CE Smith Bunk-Style Guide-Ons for Boat Trailers - 24" Long - 1 Pair
- Video: CE Smith Bunk-Style Guide-Ons for Boat Trailers Feature Review
- Shop: Kenda Karrier KR53 ST225/75R15 Radial Trailer Tire with 15" Black Mod Wheel - 6 on 5-1/2
- Search Results: tongue jack cover
- Shop: Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Shop: Bow Roller Assembly w/ Bells for 4" Wide Bracket - TPR - 1/2" Shaft - Black
- Shop: Yates Bow Roller for Boat Trailers - TPR - 4" Long - 1/2" Shaft - Blue
- Article: Trailer Wiring Diagrams
- Shop: CE Smith Bunk-Style Guide-On Kit for Boat Trailers - 90 Degree Posts - Pre-Galvanized
- Search Results: boat trailer guide posts
- Video: A Closer Look at the Weigh Safe Flap Jack Folding RV Stabilizing Block
- Q&A: Can a 1-7/8 inch Ball be Used to Replace a 2 inch Ball on a Trailer that is Hard to Unhook
- Q&A: CE Smith Bunk Board Guide-Ons Spacing Required From The Boat On The Trailer
- Q&A: Could Brackets of CE Smith Bunk-Style Guide-Ons for Boat Trailers # CE27660 be Painted Black
- Q&A: Should Boat Trailer Guide Ons Touch Boat When Installed
- Q&A: Are Roller Bunks or Keel Rollers Needed on the CE Smith Boat Trailer Part # CE48810
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Search Results: trailer tires and wheels
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Shop: Suspension Enhancement
- Search Results: trailer jack
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
on Boat Trailer Parts
