How to Install a Hopkins Brake Controller in a 2010 Toyota Tacoma
Published 04/09/2015
Question:
I have a Hopkins impluse brake controller #47235. I want to put it on my 2010 Toyota Tacoma with factory tow package,7 pin factory rear adaptor. Will the Hopkins wiring adapter #HM47815 work correctly for this application?
asked by: Shawn H
0
Expert Reply:
Yes, to install your Hopkins Impulse Brake Controller part 47235 in your 2010 Toyota Tacoma with a 7-way all you need is the install harness part # HM47815 that you referenced.
I attached an install video that shows a similar brake controller being installed in a similar Tacoma as yours.
expert reply by:
Jameson C
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Custom Harness - Dash Knob - Up to 2 Axles - Proportional
- Search Results: redarc trailer brake controller
- Q&A: Differences Between the Redarc Tow Pro Liberty and Tow Pro Elite
- Q&A: Tips For Finding Brake Controller Port In 2010 Toyota Tacoma w/ Tow Package I h
- Shop: Curt Spectrum Brake Controller w/ Custom Harness - Dash Mounted Knob - Up to 4 Axles - Proportional
- Shop: Replacement Control Knob for Redarc Tow-Pro Liberty Electric Trailer Brake Controller
- Shop: Longview Custom Towing Mirrors - Slip On - Driver and Passenger Side
- Shop: Towing Mirrors
- Q&A: Troubleshooting Installation of Hopkins Impulse Trailer Brake Controller in 2006 Ford F-250 SD