Hi Darrin! The MORryde RV Cargo Slide Tray - 90" x 23" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR78RV can clear a lip up to 1.57 inches, so call it 1-1/2 inches to be safe. If you need it to be higher, we do also have the Height…
Hi David, I called MORyde to check the internal dimensions of the MORyde RV Cargo Slide Out Tray part #MR78RV and they confirmed the internal length is 88.21 inches long and the internal width is 19.84 inches wide. Considering the Blackstone Griddle,…
Hey Alex. From the information I can find online it does look like your 2011 Keystone Cougar 318SAB does come prepped for a second AC unit. The bedroom roof vent should be reinforced and pre-wired for a 13.5k or 15k BTU unit. To check if your trailer…
Hey Phil! For a tandem axle trailer you will want two of the Leveling Kit with Wheel Chocks for Trailers and RVs #WS28ER. You are correct, one under each tire is best. I use these on my Jayco with one under each tire to keep them off the ground and…
The Replacement Controller and RF Remote for Lippert TV Lift System #LC253395 will not work on your existing RV T.V. lift due to the controller being specific to the motor. The motor, Lippert part 325978; has it's own pigtail that plugs into the…
Hey Jonathan, RV air conditioners all fit a 14" x 14" hole so the only real important factors to determining the correct fit for you would be the BTU rating and whether you have a 6-pin or 9-pin connector. The 936000108 part number you…
Hello Herb, It's been a while, thanks for writing in. The short answer is no, the Micro-Air EasyTouch 353 is not currently compatible with the Furrion Chill Cube ducted system like the one included with #FR99TD. The Chill Cube is a newer,…
Welcome back Rich and thanks for the information! To replace your Sharp Carousel microwave R-820BK-F, I recommend the Greystone Built-In RV Convection Microwave item #GR27FR. It measures 21" wide x 11" tall x 15-3/4" deep.…
Hey Mark, welcome back! Yes, that factory damper will be removed to install the Safe-T-Plus Steering Stabilizer #ST98MR. See the photos below. I also went ahead and linked the instructions and an installation video further down on this page for your…
Hello Jerry, Thank you so much for the pictures, they are always most helpful! I am sorry but there is not a seal packing kit, you will need to replace the entire jack. For your Lippert Level Up with part number 343315-RA, you will want the…
In my experience the MORryde Wall Mount #MR82ZR will require additional mounting height to allow it to clear the storage door opening on most RV's. I have had better results using the Mount #MR38DR in the area you are looking to mount the TV.
WOW! I am impressed! I called to place my order and real person answered, spoke perfect English, albeit a slight southern accent, and my order was sent within a day, shipped quickly and I had it a few days later. I saved over a hundred dollars over local and installed it my self. I cant imagine how that they could do any better. THANKS!
Save space up high and aim your screen where you need it. A ceiling mount keeps the TV out of the way, while a swivel lets you turn it toward different seating areas for a better view. For a hassle-free fit, confirm your TV's weight and VESA mounting pattern match the mount's requirements.
Yes, some ceiling designs can be floor-mounted as long as the TV is less than 35 lbs. Verify the mount supports that orientation so the screen lifts up cleanly, and double-check clearances so it doesn't bind. Use the same VESA and weight checks you would for a ceiling install.
Pick a mount with a way to hold or lock the viewing angle. If a setup can't lock, it may float where it wants. Look for adjustable tension or a locking feature in the swivel/tilt and set it during install to help keep the TV where you want it.
Plan around the mount's drop and the TV's centerline. Some hang down 12-3/4 inches when fully extended. Measurements like approximately 9-1/2 inches from ceiling bracket to center of TV bracket flipped down, and approximately 7-3/16 inches when flipped up, help you size the screen and avoid obstructions. If space is tight, check arm length since it can limit larger screens.
Match your TV to the mount's weight rating and VESA pattern. You'll see options rated 25 lbs or 35 lbs with 75 mm x 75 mm, 100 mm x 100 mm, or 200 mm x 200 mm patterns. Up to about a 40" can work if it meets the weight limit and bolt pattern. If you want to view from multiple spots, confirm the swivel range you need, such as 180 degrees or 360 degrees.
75 mm x 75 mm
RV TV Mount Parts or Accessories
Filters
