Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…
Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…
Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…
Hey Jerry, does the LED still light up on the front of the Mighty Cord SurgeMinder Surge Protector and Circuit Tester #SU39SR? If it was actually overloaded it would have damaged the internals of it and it wouldn't work as a surge protector any…
Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…
Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…
Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
Hey Scott. The Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump like item #FR97TQ in black or item #FR67TQ in white are only available in 18K btu capacities. The Chill Cube uses variable-speed technology, which allows it to reduce…
Hey Steve, yes the Dexter Nev-R-Adjust Brake Assembly set part #23-458-459 is the correct set for your Airstream based on the part numbers you mentioned. Also the hub/drum part #8-388-80UC3 that you referenced as well would be correct for your…
Hey Ken, welcome back! The Chill Cube #FR24TQ is just the rooftop unit. The #FR67TQ is the rooftop unit with the air distribution box (ADB) and the remote. This is everything you need for a complete installation. The #FR59TQ is the AC unit with the…
Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…
Very easy process, good prices and my products were shipped on time and were delivered on time. The instructional videos online helped make installation easy!
Ryan
Portland, OR
RV Interior Lights with LED strip style
From awnings to cabinets, a strip light tucks in where you want even coverage, and the LED light brings bright output. Options install easily, fit into existing tracks or fixtures, and can adhere under a camper when the surface is clean. Handy for replacements or adding light along ceiling supports and work areas.
Some LED strip lights are dimmable and include a remote, while others have a single brightness. Check if a controller is included or required for dimming. If running two strips, confirm the controller has two leads and match +12V and color markings; seal any cut ends to protect them.
Yes, LED strip lights can provide excellent, bright light on a 12 volt supply. Verify your power source matches the strip's voltage and polarity before wiring. For damp areas like a shower stall, choose a weatherproof strip and seal any cut ends to help protect it.
Clean the surface thoroughly for the best adhesion and let the tape cure for at least 24 hours. 3M tape can attach great to supports; in high heat, consider a more permanent adhesive. If using a screw-mounted strip, check that the screw holes fit your fasteners—some may be tight for self-tapping screws.
Often yes. LED strip lights have gone into existing fluorescent fixtures and old awning tracks with easy installs. You may need to solder a pigtail from your old lights, cut to length, and weather-proof the cut end. If instructions use small illustrations, take a moment to review them closely before wiring.
Filters
