Is There PSI Limit for Dexstar Steel Mod Trailer Wheel # DEX69FR

Question

Question:

What is the max psi on this wheel

asked by: Chris

0

Expert Reply:

Hey Chris, you'd actually be limited by the PSI rating of the valve stem used in the Dexstar Mod Wheel part # DEX69FR long before you'd find the limit of the wheel itself. We have higher PSI valve stems like the part # AM20906 that you could use and you'd be set. This can handle over 100 psi. What tire do you have?

expert reply by: Jameson C

0

Seadog

4/21/2026

I bought this same wheel for my 14K dump trailer. Etrailer was way less expensive then the dealer for the same rim. My tires are 14 ply and have a cold inflation of 110 psi; I also bought the steel valve stem. I have not experienced any issues with the rim or valve stem. I did not look on the rim for a Max psi rating

Jameson C.

4/21/2026

@Seadog thanks for sharing that!

Steve

4/21/2026

I have the same rim. I used the had valve stem and I am running 16ply tires at 120 psi. I don’t mind overkill on things like this. I’d rather make it back home than be stranded somewhere because I was trying to save a couple of dollars.

Answer 1

You always need to keep your trailer tires filled to the max cold psi rating. If your current load range G tires have a 110 psi rating then that is what you need to keep them filled to. Tire blowouts are a result of damaging a tire (like hitting…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Is There PSI Limit for Dexstar Steel Mod Trailer Wheel # DEX69FR

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching