Accessories And Parts

RedVision Manager30 management system controls multiple on-board devices in your RV so you can turn lights, inverter, water pumps and tanks, and electric steps on and off. It also acts as a 240-volt charger, solar regulator, isolator, and controller.

Diverter system allows you to redirect water from your RV's city water inlet or your fresh water holding tank. Eliminates the need for an exterior gravity fresh water fill. Used as a direct replacement for original version that came with your RV.

Stop standing idly by while your RV's fresh-water tank fills up. Tank filler uses a vented bayonet-style cap to hook onto your gravity fill inlet so you can be completely hands free. Includes brass shut-off valve so you can control the flow.

Foil covered heater is used to prevent your RV fresh water or septic tank from freezing. Built-in thermostat automatically turns on when the temperature drops below 34-degrees F. Measures 30" long x 13" wide with a 24" ground wire.

Get a new Valterra ABS fresh-water tank ready for installation or repair damaged fittings on an old one. Kit includes a straight-in inlet and (2) 90-degree elbows for the outlet and vent. Includes ABS cement for leakproof fitting.

Attach to your drinking water hose to fill up your RV's fresh-water tank in half the time. Feeds water into your gravity fill inlet without any splashback, so no more soggy socks. Shut off valve lets you control the flow.

Get a new Valterra ABS fresh-water tank ready for installation or repair damaged fittings on an old one. Kit includes a threaded cap inlet and (2) 90-degree elbows for the outlet and vent. Includes ABS cement for leakproof fitting.

Dual-barbed drain cock replaces 1 worn or damaged drain tap in your RV's fresh water tank or system. Fits most fresh water valves. Barb measures 3/8" to 1/2".

Attach to your drinking water hose to fill up your RV's fresh-water tank in half the time. Feeds water into your gravity fill inlet without any splashback, so no more soggy socks.

Full-contact, weatherproof heating pad helps prevent your RV holding tank or step from freezing. Built-in thermostat automatically turns the heating pad on and off depending on the temperature of the tank or step. Easy, peel-and-stick installation.

Dual-threaded drain cock replaces 1 worn or damaged drain tap in your RV's fresh water tank or system. Measures 3/8" to 1/2" MPT.

Get a new Valterra ABS fresh-water tank ready for installation or repair damaged fittings on an old one. Kit includes a 90-degree inlet and (2) 90-degree elbows for the outlet and vent. Includes ABS cement for leakproof fitting.

Replace or install a new fitting on a Valterra ABS plastic fresh-water tank. Straight-in fill fitting has an MPT connection for a 1-1/2" FPT cap or threaded collar. Flange attaches to fresh-water tank with ABS cement for leak-proof installation.

Replace or install a new fitting on a Valterra ABS plastic fresh-water tank. Straight-in fill fitting has a barbed connection for 1-1/4" hose. Flange attaches to fresh-water tank with ABS cement for leak-proof installation.

This 5/8" diameter fill tube lets you fill your RV's water tank at or near full pressure while minimizing backflow. The quarter-turn, pressure-sealed valve lets you selectively control water flow.

Transport your Front Runner 17.7 gallon water tank (sold separately) on a flat surface using this easy-to-install mounting system. Metal straps fit in tanks molded slots and attach to flat surface. Black powder-coated steel resists corrosion.

Seal the factory-opened port on your Valterra ABS fresh-water tank if it's not in the location you need. Plug uses 3/8" MPT connection for a secure, leak-proof closure.

RedVision management system allows you to control multiple on-board devices in your RV so you can turn lights, inverter, water pumps and electric steps on and off. It also provides you with the ability to monitor water levels and temperatures.