2004 Ford F-150 Cabin Air Filter

Hey Liz, thanks for reaching out. Yes, the Tamarack ST225/75R15 Trailer Tire with Black Eagle Aluminum Wheel #CR99ZR is a matte black aluminum wheel. It's the same matte black coating as the #WST69FR wheels you've ordered previously. It has a…

Hey Tris. I attached a diagram below that will show you the dimensions of the etrailer Manual Sidewind Trailer Jack w/ Drill Adapter item #e88GV. From the mounting plate to the bottom of the jack foot is 9-1/8". The etrailer Manual Sidewind…

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

The Bulldog Replacement Sidewind Gear Kit #BD500212 that you referenced is the correct repair kit for your Bulldog square tube jack according to my contact at Bulldog. The top cap you can use is part #BD017802. After you repair the jack you will want…

We do have the replacement screw and gear kit for your 12K Bulldog 180 Series Jack. You will need Gear Kit #BD500212 and Screw and Nut Kit #BD500217. You will also need grease for the new gears, so if you don't have any use #L11316. I included a…

Hey David, thanks for reaching out. That is a slick camper. Your 2017 Airstream flying cloud uses a #11 Dexter axle. It uses a #25580 (1.75" inner diameter) inner bearing and #M67048 (1.25" inner diameter) outer bearing. We can provide…

Hi Mark; have you tried looking behind the center dash storage pocket? Technically on the vehicle the location is BH7. It will be similar to the attached picture on an Expedition. You can also take a look at the installation video I attached further…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The Buyer's Products plate mount hitch, part #33710052, has the standard 1-3/4 by 3-3/8 inch bolt pattern for mounting to a plate. I've linked our selection of mounting plates for you as well.

Hello Brian, Yes, on the Buyers Products 10 Ton Combination Hitch with Mounting Kit 2" Ball BH10 Series #33710052 you can swap out the 2" ball with the Replacement 2-5/16" Ball with Nut For Buyers Products Combination Pintle Hitch…

Yes, Tekonsha released the part #3062-P which is a brake controller install harness that fits your 2019 Subaru Ascent and would work well. I attached a picture that shows where you'll find it on your vehicle too. For a brake controller I would…

Hey Steve, yes a Rock Tamers mud flap kit like the part #RT47VR would work with the Weigh Safe adjustable ball mounts part #WS68RR and #WS56ZR. The ball mounts have enough clearance on the shank to allow the Rock Tamers to fit.