What Is The Mounting Hole Spacing For The TecNiq Tri Bar Heavy Duty ID Bar TN52TR?
Published 11/12/2026 >
Question:
What’s the mounting bolt spacing to attach this to your trailer or vehicle?
asked by: Bryan
0
Expert Reply:
Hi Bryan!
The TecNiq Tri Bar Heavy Duty ID Bar - 16.5" - Red Lens # TN52TR has a 6" on center bolt pattern for mounting. I included a diagram showing this as well. The diagram also has all the other measurements for the light, so it should have everything you need in it! ^___^
What are you wanting to mount this on?
expert reply by:
Lazer S
0
Product Page this Question was Asked From
TecNiq Tri Bar Heavy Duty ID Bar - 16.5" - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Surface Mount
- LED Light
- 16-1/2L x 1-1/4W Inch
- Red
- TecNiq
more information >
Continue Researching
- Q&A: Wiper Blade Recommendation For 2027 Kia Telluride EX Hybrid
- Article: Trailer Lighting Requirements
- Q&A: Replacement Master Cylinder for Older Model Titan Model 60 Brake Actuator
- Q&A: What Size Hole Needs To Be Drilled For a 2" Round Recessed Trailer Marker Light?
- Q&A: What Size Hole Does the Peterson LumenX LED Clearance and Side Marker Trailer Light Mount In?
- Q&A: Replacement Switch for Hopkins Breakaway Kit
- Q&A: Longer Hitch Pin Recommendation for Toyota Sequoia Trailer Hitch
- Q&A: Recommended Lights To Illuminate Bed On 2 Level Utility Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations



Bryan
11/12/2026
Awesome thanks for the speedy reply and information! Always enjoy the customer service of e trailer staff