Replacement Lippert Components Correct Track Axle Hanger - Qty 1

Video Transcript for Feature Review Replacement Lippert Components Correct Track Axle Hanger

Ellen: Hey everyone. I'm Ellen here at etrailer.com. Today we're taking a quick look at the Correct Track Axle Hanger. This is going to be a replacement for a damaged or broken or maybe missing Correct Track axle hanger that was welded to the frame of your trailer by the manufacturer. This is going to be a direct replacement for that. It does still have the bare, or raw, finish to it so it can still be welded onto your trailer.As far as the measurements, I'll grab my handy dandy ruler here.

We can take a look at it. It's about three and a half inches long by four inches tall, and then to the outer flanges here, it's just about three and a quarter inch wide. The inner width there is about two inches, so we'll have about two inches of space. The distance from the top of the hanger to the center of that attachment hole is just about three and a quarter inch. That little slot down there is about an inch and a half across and about five eighths of an inch tall.I hope that's helpful in determining if this is going to be the right hanger for you.

We do have other components for the Correct Track axle or the Correct Track system. You can find that right here at etrailer.com. But that's pretty much all there is to it for our Replacement Lippert Components Correct Track Axle Hangar. Thanks for watching and we'll see you next time.