Recommended Replacement Marker Lights For a Vintage Trailer With 2-1/2" Round Lights

Question

Question:

Im looking for replacement lights for a vintage camper trailer. My marker lights need replaced. They are 2.5 inch round with a brown wire and a white ground wire running to each. I need some help finding the right replacement. Thank you.

asked by: Hillary

0

Expert Reply:

I recommend considering the LED Trailer Clearance/Marker lights. These are available in Red # 328-K-500B and Amber # 328-K-501B. They are the same 2-1/2" diameter and have a simple 2 wire connection like your current lights. The LED diodes use far less power than the incandescent lights you likely have so it is easier on your older wiring.

expert reply by: Bud M

0

Answer 1

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 2

If what you really need is a new axle you can go to a local trailer shop to you and have them custom order you the exact specs you need for a trailer axle. But to attach springs to your 1-1/2 inch square axle you would want the mount plate part…

view full answer...

Answer 3

Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…

view full answer...

Answer 4

We have checked with Atwood and can confirm for you that the Replacement Black Door #AT91507 or white #AT91386 are a confirmed fit for your 6 gallon Atwood GC6AA-10E water heater.

view full answer...

Answer 5

The equalizers that come with the Dexter Heavy-Duty Suspension Kit #K71-448-00 have bolt holes that measure 6" apart on center and then 4" tall on center as you can see in the attached photo. You'll want to measure your current…

view full answer...

Answer 6

I reached out to my contact at Lippert and the issue you are describing on the Kwikee Steps on your 2013 Itasca Meridian 34B is a tell tale sign of a bad controller. The cause is the controller is not detecting the amp draw of the motor when the…

view full answer...

Answer 7

If your step motor marked "REP 851" and the Part Number sticker says "32 Series Step," the replacement step motor kit you need is the Kwikee #LC379145 Motor Upgrade Kit. You can further confirm that you have a Series 32 step kit…

view full answer...

Answer 8

I wasn't able to find the picture you were referring too, however in the instructions for the GC6AA-10E and was able to locate the heating element; It is shown as item 17 in the image below.

view full answer...

Answer 9

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

view full answer...

Answer 10

When it comes to snow chains for your 2017 Roadtrek RV with 225/75r16 tires I recommend going with the Glacier V-Bar Snow Tire Chains #PWH2819SC, which are a fit for your tires. With that being said, you'll want to check your owner's manual…

view full answer...

Recommended Replacement Marker Lights For a Vintage Trailer With 2-1/2" Round Lights

Product Page this Question was Asked From

Continue Researching