Replacement Landing Gear for 2007 Keystone Raptor

Question

Question:

Will this Landing gear set work to replace the landing gear on my 2007 Keystone raptor RP3612dp?

asked by: Eric G

0

Expert Reply:

You'll want to confirm the distance between the weld stops where your current landing gear are installed to determine which landing gear set can be used as a replacement. The # RVLG-8000 has 15-1/2" measured from the inside of the weld stop on top to the inside of the weld stop on the bottom, and 17-1/2" from the outside of the top weld stop to the outside of the bottom weld stop. This landing gear set has an 8000-lb capacity and 36-1/2" total lift.

If you need a manual crank handle for this landing gear set you can use the # RVLG-HDL. If you wanted to add a motor to this landing gear set you will want to use the # M1230 and a switch can be added with # LG-145236.

expert reply by: Erik B

0

click to enlarge

Answer 1

First thing I'd check is the power source and ground for the landing gear. What you described could be a bad motor, but a weak battery or ground will cause the same problem. Your picture is pretty close up, but it looks like the motor you'd…

view full answer...

Answer 2

We do have motors that you can add to your landing gear. For example, the Landing Gear Set #RVLG-8000 can be operated with the manual crank #RVLG-HDL but you can also add the motor #LC142178 and switch #LG-145236 for effortless operation on your end.…

view full answer...

Answer 3

Hey Bob, Landing gear components aren't all interchangeable between brands so I'd need to know the exact model to find replacement parts for your current system. If you're just wanting to replace the landing gear as a whole then I'll…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The gearbox #RVLG-RDBOX for the Landing Gear Set w/ Handle #RVLG-8HDL can be mounted in the horizontal or vertical position. I went out to the warehouse and tested both the gearbox and lead leg together and the pins that hold the gearbox in place…

view full answer...

Answer 6

The only difference between the #RVLG-8HDL and the #RVLG-8000 is that the #RVLG-8HDL includes the manual crank handle, while the #RVLG-8000 doesn't. The dimensions for both are the same. • Retracted Height of 32-3/4 inches • Extended Height of…

view full answer...

Answer 7

There are a few things that go into making sure you choose the correct replacement landing gear. First you need to be sure that the landing gear is rated properly. If you check out the weight rating on your current landing gear just make sure the…

view full answer...

Answer 8

Hey Frank, since Atwood is no longer in business we can't get replacement legs for their setups which means your best option is to replace everything like with the Lippert #LG-4 that you referenced. We do know that the Lippert kits do fit the…

view full answer...

Replacement Landing Gear for 2007 Keystone Raptor

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching