Videos
for Toyota 4Runner Owners
Help Articles
for Toyota 4Runner Owners
Expert Answers
for Toyota 4Runner Owners
To make the physical connection between the Roadmaster #RM-676 Nighthawk tow bar and the tab the D-ring is connected to, you'd need the #RM-035 for 7/8 or 1 inch wide tabs or #RM-035-1 for 3/4 inch wide tabs. I'd also recommend you check with…
view full answer...The best way to attach safety cables like #RM-643 would be to use safety cable extensions like #RM-910648-20 and loop them around the frame members just behind the bumper. This is confirmed by Roadmaster.
view full answer...The Hopkins 6 Pole to 7 Pole Adapter, #47435, does have a pin for the brake output for a brake controller. This adapter will work for your set up as long as the center pin of the 6-way plug on your RV is for 12v power and the pin in the 10 o clock…
view full answer...Hey Joe, yes the Curt TruTrack 2P part #C79JR does allow backing up as long as you are backing up mostly in a straight line. If you are going to get close to jackknifing the trailer at all though you would need to remove the springs bars. This is…
view full answer...As long as you do not exceed the tongue weight capacity of the #GY87VR it could handle your bike and bike rack. This has a tongue weight capacity of 700 lbs so it won't be a problem. However, if you think you might tow your popup camper and also…
view full answer...Hey Joel, There are a couple important differences between the Thule Camber 4-Bike Rack #TH9056 and Thule Apex XT 4-Bike Rack #TH9025XT. One of them is indeed the locks, as the Camber does not have locks while the Apex comes with a lock for the rack…
view full answer...For your tire size of 275/70-17 the Konig tire chains part #KON94FR are an easier to install set that provide excellent traction and will last a long time as well. On a two wheel drive truck you can get by with a single set installed on your rear…
view full answer...For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly. To test power,…
view full answer...Based on my research, the replacement screen door slide for your RV door is the Lippert Components Screen Door Bubble Slider Panel #LC234101. The Lippert part number 302-027-CL has been replaced by #LC234101.
view full answer...You're looking for the Replacement Barrel Nut for Yakima SkyBox Rooftop Box #Y8870083, which according to my contact at Yakima is 1-1/4" long and has a 1/4"-20 thread pitch.
view full answer...The Curt Friction Sway Control Kit part #17200 and Reese Friction Sway Control Kit part #83660 are both very similar. I recommend the Curt because it comes with a weld-on sway control tab for use without a weight distribution head so that makes it a…
view full answer...The Curt Friction Sway Control, #17200 and the Reese Friction Sway Control, #83660 are very similar. Friction sway control systems are a simple design and don't vary much in how they work. As soon as your trailer begins to move out of line, the…
view full answer...




































