Custom Fit 2008 Ford F-150 Accessories

Hello Lou, thanks for reaching out. The hitch pin you are looking for is the etrailer D-Shape Anti-Rattle Locking Hitch Pin for Benton Hitch Accessories #e43JR. This will work with the Benton #B54VR bike rack you mentioned, as well as the #B54FR,…

The SumoSprings Solo Custom Helper Springs #SSR-121-54 will include 2 sets of M10-1.5 bolts for mounting in place of the factory bump stop. The lengths are going to be 55mm and 80mm to account for the different height spacers that you may need.

They're pretty easy to use and get set up. Not sure about you or your parents abilities but a second set of hands getting the bike rack installed in the receiver is always helpful though. The Benton LittleShift Bike Rack item #B54VR weighs only…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I can help you navigate those tight turns in your 2014 Ram 2500. Since the Convert-A-Ball Cushioned 5th-Wheel-to-Gooseneck Adapter #CAB-C5GX1216 that you referenced does not move the pivot point further back you really do not gain much clearance for…

What you will need in order to convert your 4 pin connector to a 7 pin connector on your 2008 Ford F-150 is Adapter 4 Pole to 7 Pole and 4 Pole part #37185. This adapter will allow you to use a 7 pin trailer connector and have the option to use a 4…

For a Dexter 3,500 lb trailer axle hub the correct replacement wheel stud is the part #7-122.

I reached out to my contact at Dexter and for a replacement stud compatible with the Dexter Trailer Hub #K08-426-91 you have you will need the #7-122. This will be slightly longer than your current studs but all of the other dimensions are the same.…

I looked up your owners manual in a web search and was able to find that fuse 33 in the fuse box in the passenger side of your cab is one place to check. Relay 44 and relay 56 in the engine bay power distribution box also impact that 12v Power at…

First, in order to get a 7-way for your 2008 Ford F-150 with a factory 4-flat, what you'll need is the Adapter 4-Pole to 7-Pole #37185. For the wiring itself, I have added a link to a help article below which covers it in detail, but what you…

To install a brake controller in your 2008 Ford F-150 you would be able to use the brake controller port under the dash and you will need to complete the wiring at the rear of your vehicle to the 7-way at the rear of the truck. For a brake controller…

Unfortunately there's not a way to pin point the axle capacity based solely on its diameter or the size of its suspension components, although with a 3" axle you're probably looking at something that has at least a 4,400 pound rating…