Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…
view full answer...It's unfortunate your awning lost that battle to the tree, but hopefully you can take at least a bit of solace in knowing that you certainly aren't the first one (and won't be the last) this has happened to, and trees are, to the best of…
view full answer...I attached a picture that shows what the typical dual tank setup looks like with the accessories needed labeled. First thing you need is pig tails to go from the tanks to the regulator like the part #100473-12. Then for a dual tank regulator with…
view full answer...Hi Peter, Yep, there sure is a Roadmaster Comfort Ride system that is designed to work with a triple axle trailer with 7,000 lb axles like you have on your Keystone Carbon. The correct part for you is the following: - Roadmaster Comfort Ride Leaf…
view full answer...Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…
view full answer...In order for a vertical and horizontal regulator to "breathe" and function properly, the vent opening must be pointed down. The writing on your Marshall 260 warns you about this at the bottom of of the etching. If your regulator is mounted…
view full answer...Thanks for reaching out! While we don't carry that specific brand, there are some common operations between dual two-stage regulators so I'll be able to shed some light onto the subject for you. When using a two-propane tank setup you'll…
view full answer...Yes you should use some kind of sealant on threaded fittings whether it is the tape or pipe dope. We recently had a propane manufacturer visit us for training so I can say for sure that yes you should use a sealant on threaded fittings. No sealant…
view full answer...The only sort of grease cap we offer for a threaded 1.98" hub bore is the Bearing Buddy Bearing Protectors part #BB1980T-SS which contains fine threads. This is the only option we'd have save for new hubs as most standard grease caps just…
view full answer...Trailer magnets are designed set up for each brake assembly size axle capacity. If you check out the link I attached you will see all of the magnets we carry. From there you will need to click the brand you have, the size assembly you have, and then…
view full answer...The closest modern equivalent to a 6.50-13 tire is a 175/80-13. The tire and wheel combo, #AM3S030, that you have referenced has this tire size. This tire comes mounted on a wheel with a 4 on 4 bolt pattern. We also have this tire size with a 5 on…
view full answer...How tall are the bed rails of your truck from the bed floor to the top of the rail? The tool box #BAK72204 is pretty tall at 19-1/8 inches so it may not be short enough to fit under the top of the tarp. But if you can verify the height you have of…
view full answer...Filter Your Search
Contact and Help