Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Yes, the CE Smith Trailer Hub part #CE13511 will fit as a replacement for your DICO hub 45264 but you will need to use a different seal as we have found that your spindle diameter is slightly different which means you need the #168255TB as well.
view full answer...Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…
view full answer...You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…
view full answer...The ST205/75R14 tires like #AM10235 are 26.3 inches outer diameter. Where the ST205/75R14 ties like #TTWTRTM2157514D are 27 inches outer diameter. So there is even some variety in the same size tires even within radials which can be a little…
view full answer...If you check out the picture I attached you will see where I pointed out where the sticker is that has the VIN on the Yakima Rack and Roll trailers like the part #Y08106. If somehow the sticker is worn off or unreadable my contact at Yakima said that…
view full answer...An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…
view full answer...I recommend having the Demco A-Frame Trailer Coupler #DM14791-97 welded on in place of the Sleeve-Lock #CA-5196-B style coupler that you currently have. This Demco coupler uses a 2" hitch ball the same as your current coupler and is rated for up…
view full answer...This is a fairly straightforward install. GM has already run some of the necessary wiring from the rear frame rail area to the engine compartment, so you will see a blue wire for the electric brake function, and an orange wire which provides 12 volt…
view full answer...For a trailer that has an angle iron frame like what you have what I would recommend is a system like the Reese Steadi-Flex part #RP66558 you referenced and have the outer brackets welded to the frame of the trailer since there isn't a clamp on…
view full answer...I would be happy to help you find a brake controller for your 1989 C/K Series Pickup. I recommend the Curt TriFlex Trailer Brake Controller item #C24VV. This is a proportional brake controller that works with trailers having up to four axles. It…
view full answer...Replacement Left Side Fender for Yakima Rack and Roll Trailers - Qty 1 #Y8880164 and right side #Y8880163 are intended to be priced equally. The reason why they are not at this moment is that the right fender is on sale in our system. Why they both…
view full answer...The mounting holes are 3" apart on center and 1" from the top on the Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 3,500 lbs #CT-3002-Z.
view full answer...Filters
4378 results
Vehicle Fit
Fit 1997 Ford Ranger