2006 Hyundai Tucson Salt Spreader

At this time we only know the Replacement Clutch Assembly #3371401150 to work on the following salt spreaders. Air-Flo part number A40032 Henderson part number 51873 Swenson part number 04138-017-00 Hi-Way part number 41719 Meyer part number 61167…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I have included a picture that shows what Curt hitch #C13140 looks like when installed on a BMW X1. The picture is from the instructions which I have also linked for you. As you can see the receiver opening is the only part visible beneath the rear…

We do not offer the Pullrite brand but in my research it does appear to compare to our Demco Hijacker AutoSlide like #DM8550024. Both the B&W and Demco 5th wheel hitches are…

Let's start with the roof rack, and for your husband's 2016 BMW X3 with flush mounted rails on his roof,…

Hey John, so the correct amount of spring bar tension will be based on the trailer's tongue weight and how it affects the suspension of your Nissan Frontier. Every WD system is…

Yes, it will but you'll lose some functionality by the 2" receiver. All of the hitches available for the…

Thanks for the pictures! The best hitch for your 2023 Mercedes-Benz Sprinter 2500 is the etrailer item #e82TR. This hitch is custom fit and bolts to your Mercedes with included hardware. This is a class III hitch with a…

We sure do! The correct replacement slide out motor for your Power Gear 1510000042 is part #LC88UD on our site.

There is no adapter available that will go from a 7-Way vehicle side connector to a 6-Way square Jayco connector. You will need to make one using the follow parts: 7-Way trailer connector #H20042 6-Pole Square Trailer Wiring Connector Kit, #37995…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…