Result: winch stand

We do carry a few different L-shaped trailer fender mounting brackets such as the Mounting Brackets for Trailer Fender part #CE26098G-2 which is for 13"-15" wheels. The brackets have pre-drilled holes but they are mostly universal and you…

Since the Malone Microsport trailer part #MPG460G has a tongue width of 2 inches you could use the tower kit part #CE31013G which is 30 inches tall as this is designed to fit 2 inch channels. Then you could use a winch like the Buyers Products part…

I attached a picture that we recieved from a customer that shows the CE Smith winch mount #CE31013G installed and in use on a trailer for you to check out.

The 2x2 inch square axle is likely 3,500 lbs or less capacity. I would need more spindle dimensions or bearing numbers to assist. If you pull a hub and measure at the spindle where the bearings and seal ride using the digital caliper like #PTW80157 I…

The Malone EcoLight Sport Trailers like item #MAL43FR have 8" tires with a 5 on 4-1/2 lug pattern. The Kenda 205/65-10 Bias Trailer Tire with 10" Galvanized Wheel item #AM3H490 would work as a replacement but you will most likely have to…

Hi Michael, While we don't have any way of knowing what winch stand goes on any specific trailer, it is possible we have an option for a winch stand for your Karavan trailer. The only option we have for a stand is the CE Smith Winch Stand…

My suspicion is that you have a poor ground connection somewhere on your trailer. The fact that everything works fine until the running lights are turned on is the dead giveaway. When the tail lights are turned on, the trailer lighting is drawing…

If you look at the provided photo, you can see the hole spacing on the mounting pad of the Buyers Products #337HW800S 800 lb capacity trailer winch. 1/2 inch hardware is recommended.

In order to add a 7 way connector to your 2021 Toyota RAV4 TRD you'll need the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires #ETBC7 (for wired brake controllers) or the #ETBC7L (for a wireless…

We have a U-bolt type carrier that fits 4 bolt spares like yours. For that we have the part #CE22007Z-11050-2. Or if you are looking for a carrier that holds the wheel away from the trailer you'd want the part #FSTC1000301.

The only way to get a new control panel would be to replace your entire Smart Jack with part #LC643589. I reached out to my contact at Lippert who confirmed that the only replacement parts for the jack includes hardware like the pin or the footplate.…

I do have a solution for you, but you will not be able to use any of the traditional dual hitch adapters, since these are designed primarily for flat towing. The Malone 2" Dual Purpose Hitch Receiver you linked to your question is unique, since…