Search: nuts   >  

The number 61101 isn't actually the part number, but I believe you are looking at the Atwood 84132. If this coupler is not opening enough to engage the ball, the first thing to check is the trigger lock. If it is not disengaged, the ball will not…

A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…

According to my research, the Artis PDS1RV25 water pump is a 12 volt, 3 gallon per minute pump, and we do have the perfect option for a replacement: - Flow Max RV Fresh Water Pump #LC689052 This is also a 12 volt, 3 gallon per minute pump, though it…

From what I was able to find it looks like the 4440170 is the #L68149 and the 4440160 is the #L44649 bearing. We don't have anything that matches the dimensions on that seal, the closest thing is the 10-19 seal #RG06-050. This has an inner…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

Good news! I was able to get a exploded diagram as well as a set of instructions on how to replace the rod and gears #TJD-12000-RODNUT in the #12000 Series Ram Jacks made after 2012. I have attached them to this page for your convenience. Basically,…

According to Dexter Axle, the attachment bolts for a 12 x 2 brake assembly should be torqued to 25-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

The pilot diameter on a wheel, like the one with part #AM30620, is the diameter of the bigger hole that is directly in the middle of the wheel. The pilot hole diameter of the wheel for the part I just measured is 2.84". I have attached a picture…

There isn't a way to install zerk fittings on your spindle to make it an EZ lube spindle, but we do have Bearing Buddies which are designed for spindles like yours that do not have the zerk fittings to make installing grease in them easier. You…