Are New Backing Plate Bolts Included With Electric Brake Assembly for 6K Axles # 23-459  

The Electric Trailer Brake Assembly #AKEBRK-7R-D could potentially work on a mobile home axle, but it would depend on your axle. Not all mobile home axles are going to be the same and most will not be compatible with the #AKEBRK-7R-D. Mobile homes…

My contact at Dexter Axle tells me that when installing a brake assembly to the backing plate of a 3500 lb axle, the bolts should be tightened in a criss-cross pattern to between 45-70 foot lbs.

The Dexter Trailer Brake #23-105 you referenced uses a common ALKO 5-bolt mounting pattern: 5 on 3-7/8-inches. The matching brake flange for this pattern is #4-44-1 which fits 3-inch round axles.

According to Dexter Axle, the attachment bolts for a 12 x 2 brake assembly should be torqued to 25-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

When installing the 12" Nev-R-Adjust Electric Brake Assembly, #23-459, you would need Brake Mounting Flange, #4-44-1. I have included a picture with measurements listed. Welding of a brake mounting flange is a precision job that requires the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…