Search: c56070   >  

The Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY38FR is not going to allow for any additional turning clearance than the 5th wheel king pin with a fixed point hitch. We have offset gooseneck ball options depending on what type of…

They do not make an aftermarket puck system kit for your 2019 Ram 3500, so you have a few options to get a 5th wheel hitch installed. The standard way is installing above bed rails #C16430-204 to use a sliding 5th wheel hitch #C55DR if you have a…

The one really big downside to gooseneck towing is that there isn't a great solution for short bed truck clearance unlike fifth wheel towing. With fifth wheel hitches you can use a slider hitch and have the clearance issue handled. With gooseneck…

I have a B and W Gooseneck hitch I can recommend for your 2016 Ram 2500, but the fits for the 2016 models are different from the 2006 models. You would need the B and W Gooseneck part #BWGNRK1384. I attached an install video for this hitch for you to…

According to my research, the 2007 Silverado 2500 Classic has a towing capacity that varies from about 10,100 to around 15,000 lbs depending on how the truck is equipped so you'll definitely be exceeding the towing capacity of the truck as well…

The gears of the 21k Demco Hijacker #DM8550035 are a bit heavier duty than the 18k capacity version #DM8550034 to allow it to have a higher capacity. The lighter duty hitch weighs 276 lbs and the heavier duty version weighs 308 lbs. To install this…

It depends on the dimensions of the recessed gooseneck, but it is possible you can use the Shocker 5th Wheel to Gooseneck Pinbox for Lippert 1716/1116/0115 and Fabex #SHK55MR. If you take a look at the diagram from Shocker you can see the necessary…

I checked with my contact at B&W for the weights of the individual component parts in their under-bed 5th wheel hitch kit consisting of parts #BWRVK3400-5W and #BWGNRK1067-5W. The weight of the head unit is 75-lbs; the base weighs 207-lbs and the…

There's not a wiring diagram for the ARC Lighting Load Resistor for LED Lights - Quick Splice #ARC22VR however the installation is pretty simple. All you're going to need to do is take one end of the resistor and connect it to the ground on…

Yes, the Bearing Kit for #84 Spindles part #BK2-100 is correct for your Lippert Trailer Idler Hub part 122098. I confirmed this with Lippert for you as well.

First, check the back of your existing 7-Way trailer connector on your 1997 Ford F-250 HD. If the wiring harness that plugs into the back is a round connector then you can use any 5th wheel/gooseneck wiring harness that has the same round connectors…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…