Can I Add Additional Outlets To The Bed Of My 2021 Ram 1500?
Updated 02/03/2026 | Published 07/29/2024 >
Products Featured in This Question
Question:
I have a 2021 Ram 1500 Laramie with two 115V, 400W power outlets in the cab. Im trying to figure out if I can add a third outlet or a 12v outlet to the bed of the truck.
asked by: Matthew S
0
Expert Reply:
Hello Matthew. It is possible to add an outlet to the bed of your truck. To add 12V outlets to the bed you can use the Roadmaster # RM-9332 and run the wiring up to the battery using 12 gauge wire. If you are wanting to add a 7-way trailer connector to the bed you can use the Curt # C56000.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- 7 Blade
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Q&A: How to Hardwire a 12 Volt Accessory Outlet in a Truck Bed
- Shop: Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long
- Shop: 12 Volt Outlet Kit, 20 amps
- Q&A: Does Landing Gear Leg LC179013 Attach Directly to Motor
- Q&A: Repair Kit for Ram Channel Tongue Coupler
- Q&A: Is There a Downside to Using Offset Gooseneck Ball Compared to Non-Offset
- Q&A: Where Does The VELIT Portable Diesel Heater Get Fuel? Is There An Internal Gas Tank?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement for Atwood Heavy Duty MPD 86065
- Article: Ram Trailer Tow Prep Package
- Q&A: Recommended Gooseneck Hitch for a 2025 Ram 2500
- Article: Trailer Wiring Diagrams
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Should You Add an Air Compressor to Your Air Bags?


Jesse M.
2/3/2026
Hey Matthew, how did things go adding the outlet to your Ram’s bed? Did the 12V outlet kit or the Curt harness end up being the better fit for your setup? Your update could make it easier for the next person working on the same project.