Search: a0500   >  

Since your tandem axle trailer only has brakes on one of the axles, you will just need a single axle kit like the Kodiak Hydraulic Brake Line Kit #18SI-BLKIT you were looking at. This kit includes an 18 foot, 7 foot and 1-1/2 foot long flexible…

Yes, I attached an install video that shows the Pollak part #PK12-707E (same as number you mentioned) installed in a newer GMC to this page.

To wire in the reverse light wire on Curt 7-Way connector #C57102 for the back up alarm to work you will need to tap into a reverse light wire behind a reverse light on your 1999 Dodge Ram. If you do not wish to tap into the wire there then you can…

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to change…

To install the Redarc Tow-Pro Liberty Brake Controller item #RED24FR in your 2019 Toyota Tacoma all you will need is the Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR. I have attached a couple of pictures…

For your 2019 Jayco Jay Flight SLX Travel Trailer and with you wanting to go boondocking for multiple nights I recommend the Go Power Lithium RV Battery - Deep Cycle - LiFePO4 - Group 4D - 12V - 250 Amp Hour Item #34282740 For a solar set up I…

The spindle that is on the Dexter Trailer Idler Axle w/ Idler Hubs #20440I-EZ-60 is a BTR spindle like part #TRU44FR. . The stub diameter (A) on the TruRyde spindle is 1-1/4 inches, The part where the grease seal rides (B) is 1.5 inches. It uses…

The Class II hitch I recommend for your 2018 Subaru Outback Wagon is the Draw Tite hitch part #36493 if your plan is to carry a hitch accessory like a bike rack or cargo carrier as it does not require a stabilizer strap like the Curt does. If you are…

Yes, for your 2015 Riverside Whitewater Retro 155 I recommend using the Curt Adjustable Trailer Hitch Receiver part #C13701. This hitch will be an excellent option for you so long as your frame rails are spaced between 18"-51" apart which…

If you have the clearance to go with larger wheels/tires that would be one way to raise the suspension. Or if your axles are above your leaf springs you can move to being below the springs and you can gain ground clearance that way as well. This is…

The Kodiak #20TA-BLKIT 20 foot brake line kit will work if the distance from the rear of the coupler to the front trailer axle is roughly 18 to 19 feet, as you'll need some slack for the swing-away coupler to move freely. having a little extra…