Result: Reverse Lockout

Hey Bill. To replace your Tie Down Model 66 actuator for drum brakes, I recommend the Demco Hydraulic Brake Actuator item #DM72VR. It has a 7,000 lbs capacity, fits a 3" wide channel tongue, and will work with a 2" hitch ball. The Demco…

We don't have any replacement parts available to fix your Reliable ACT 7.5k actuator but if you've got drum brakes you can use the Titan Brake Actuator with Manual Lockout - Bolt On - Drum - 2" Ball - 7,500 lbs Item #T63FR which comes…

Unfortunately the Atwood 85736 cannot be replaced so you'd actually need an entirely new actuator. The closest replacement we have is the Demco Hydraulic Brake Actuator #DM72VR. This actuator has a gross towing weight capacity of 7,000-lbs, a…

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

There sure is! You'll be needing the Lockout Key #DX94FR for your Brake Actuator #T4606520. Do you use the key much? Or are you using the electric solenoid?

We do have the Titan master cylinder replacement part #DX66FR which has the number 23744 stamped on the side of it. See attached picture. A lock out solenoid would attach directly to the back of the master cylinder without an adapter. If you are in…

Replacement master cylinders are specific to the manufacturer and model of the actuating coupler on the trailer. I would need to know the make and model of the actuator to determine if we have a replacement available. This information could be…

I spoke with Demco about the Demco Master Cylinder Adapter for Power Bleeder #DM10142 and they can't confirm that it'll directly fit because it would primarily depend on the size of the cap for your actuator. However they did go on to mention…

Yes, the Replacement Solenoid Adapter Fitting for Titan Model 10 Brake Actuators, part #T4750200, is for pre-2000 Titan Model 10 brakes. If you have a newer Titan Model 10 brake, you will use the Orifice Connector for Titan Actuators Item #T1209800.…

The Demco Hydraulic Brake Actuator DM8608601 you were looking at requires 1/2" x 4-1/2" Grade 5 Bolts to mount it to the tongue of your trailer. The DM8608601 was actually discontinued recently so I recommend going with the Demco Hydraulic…

The Demco #DM72VR Hydraulic Trailer Brake Actuating Coupler would require four 1/2 x 4-1/2 inch grade 5 bolts to install it on a trailer tongue. I've linked to a product description video as well as a photo with the bolt spacing that you might…

Demco does not offer a manual lockout for the coupler part #DM72VR but they do offer an electric option with the part #DM5836. They also recommend installing free-backing brake assemblies on the axles instead too which I attached a link to a page…