Recommended Mounting Hardware for Demco DM72VR Hydraulic Brake Coupler
Published 07/08/2021
Question:
What size bolts are needed for installation?
asked by: Jose M
0
Expert Reply:
The Demco # DM72VR Hydraulic Trailer Brake Actuating Coupler would require four 1/2 x 4-1/2 inch grade 5 bolts to install it on a trailer tongue. I've linked to a product description video as well as a photo with the bolt spacing that you might find helpful.
expert reply by:
Mike L
0
Bolt Hole Spacing for Demco DM72VR Brake Actuating Coupler
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Boat Trailer
- Construction Trailer
- Farm Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 7000 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Demco
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: DeeMaxx Disc Brakes - 10-7/8" Rotor - 5 on 4-1/2 - Maxx Coating - 3,500 lbs
- Search Results: mounting hardware
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Shop: Lippert Drive-In Wheel Stud - 5/8" Diameter x 2-3/4" Long - 0.689" Knurl - Qty 4
- Search Results: brake actuator
- Shop: Demco Hydraulic Brake Actuator w/ Electric Lockout - Disc - Zinc - 2" Ball - 7,000 lbs
- Video: What to Know About the Demco Hydraulic Brake Actuator-DM72VR
- Shop: Trailer Wiring
- Search Results: hydraulic brake line kit
- Search Results: spindle nut
- Search Results: bunk brackets
- Search Results: bunk hardware
- Search Results: grease
- Shop: Lippert Drive-In Wheel Stud - 1/2" Diameter x 2" Long - 0.617" Knurl - Qty 6
- Shop: Lippert Drive-In Wheel Stud - 5/8" Diameter x 3-7/16" Long - 0.689" Knurl - Qty 4
- Shop: Kodiak Hydraulic Brake Line Kit - Single Axle - 18'
- Q&A: Replacing Slipper Springs on Boat Trailer for 3,500 lb Axle
- Q&A: Replacement Surge Brake Actuator for a 2012 Jayco Pop-Up Camper
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Choosing a Replacement U-Bolt for a Boat Trailer
- Video: What to Know About the Hydrastar Hydraulic Brake Line Kit
- Video: Hydrastar Hydraulic Brake Line Kit Review
- Video: Checking Out the Kodiak Hydraulic Brake Line Kit
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: How to Add a 5-Way Connector to a Vehicle That Only Has a 4-Way Connector
- Video: Reverse Lockout Solenoid Kit for Demco DA66B Hydraulic Brake Actuators Review
- Video: Ultimate Overview of the Mounting Hardware for 10" Brake Assemblies
- Video: All About the Demco Hydraulic Brake Actuator-DM72VR
- Q&A: How to Measure a Trailer Spindle
- Q&A: Trailer Wheel Stud with Knurled Section Close to .53 inch