Search: 47425   >  

It looks like Trailer Hub and Drum Assembly - 5,200-lb Axles - 6 on 5-1/2 Item #8-201-5UC3 could be the right replacement for you. You can check the bearing numbers if you still have the bearings. If they are 25580 for the inner and LM67048 then…

I confirmed with my contact at Dexter Axle that the grease zerk used in their EZ Lube spindles like #TRU74FR is a standard 1/4-inch pipe thread fitting that you can replace with an item like #Gzerk. Your local hardware store may have one too. You…

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

The mounting bolt pattern for the Superwinch LT2000 Electric Utility Winch, #1120210, is two holes, 3.15 inches apart. This winch can be mounted in place of a manual winch and my contact at Superwinch assured me that the unit is waterproof so you…

If you are looking for a temporary solution the Trailer Connector Adapter #HM47425 is the simplest solution. You can plug it into your International dump truck and have the 7-way blade connector available. If you are looking to add a more permanent…

From what I was able to find out from my research, the Tie Down Engineering 11033 hub has a 5 on 4-1/2" bolt pattern and is designed for 3500-lb axles. Replacement hubs that have these specs typically use a #L68149 inner bearing and #L44649…

I reviewed quite a few photos of various Charmac cargo trailers and while I found some with external fenders I did not find any shown with lights installed. However, we do offer a lot of combination red/amber trailer lights and all are shown on the…

You need the Wheel Retaining Ring #33-52-1 for your 10K axles and wheels. This ring has the single tab and will allow you to use your current flat faced wheel with Coned Lug Nuts #6-109. The retaining ring will sit outside the the wheels(see image).…

Trailer Wheel Lug Nut - 5/8" #6-109 is 18 threads per inch. It has a 1-1/16" outer diameter, is 90 degree coned and fits 5/8" wheel bolts. TPI is used for standard measurements while pitch is for metric, which is why there isn't a…

For Clips only compatible with the Curt Friction Sway Control System you can use either the Spring Clip for Hitch Pins, Pull Pins and Sway Control #55515 or the Replacement Pin for Friction-Style Sway Control Systems - Qty 1 #37201001.

For a replacement clip for your Reese Sway Control System part #83660 you could use the Spring Clip part #55515.

Great news, I was able to go out into our warehouse and measure the mounting holes on this brake assembly. The center to center width measurement is 3-5/8 inches. The height measurement is 3-7/16 inches center to center. I have added an image for you…