Will the 48" Malone Fairing for Roof Racks Fit a 2020 Jeep Grand Cherokee w/ the Altitude Trim?

Question

Question:

Can you tell me if this will fit my 2020 Jeep Grand Cherokee with the Altitude trim?

asked by: Jill

0

Expert Reply:

Hey Jill. If your 2020 Jeep Grand Cherokee with the Altitude trim has the factory crossbars then the 48" Long Fairing for Roof Racks item # MAL74SR will fit them and is the correct size.

The 48" Long Fairing item # MAL74SR is designed to fit round, square, aero, elliptical, and factory crossbars. The built in clamps will secure the fairing to your roof rack.

What kind of roof rack do you have on your Grand Cherokee?

You can add this information, along with any other questions you have, where it says Add Comment.

expert reply by: Jerred H

0

MAL74SR
(click to enlarge)

Jill

7/7/2026

I have the BrightLines aluminum cross bars. Model # BL15-1-B.

Jerred H.

7/9/2026

@Jill Perfect! Those are compatible as well!

Answer 1

Hey Frank, The Malone Fairing for Roof Racks #MAL74SR brackets will be compatible with Ford factory crossbars and has a locking knob to adjust the angle of the fairing to fit different crossbar heights so you shouldn't have any issues. Both the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Will the 48" Malone Fairing for Roof Racks Fit a 2020 Jeep Grand Cherokee w/ the Altitude Trim?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching