Recommendations for Cutting the Garnish for a Ventline Roof Vent
Updated 01/27/2026 | Published 07/17/2014
Question:
I must shorten the leg length of two garnishes by about 3/4inch but before I start cutting, I would like to be sure I am using the best technique and tool before I ruin a new garnish. Please give me your expert advice.
asked by: Gary
0
Expert Reply:
I would measure the 3/4 of an inch and mark it with masking taping all around it to use a reference point for where you will make the cut. For the actual cut I would recommend you use a fine tooth saw. Some people use soldering irons to make the cut as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ceiling Garnish for Ventline Roof Vent - 5-1/8" Leg - 14-1/4" x 14-1/4" - Birch White
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Ceiling Garnish
- Ventline
more information >
Continue Researching
- Shop: Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - White - Birch Trim
- Search Results: roof vents
- Q&A: How to Trim Down Length of Fan-Tastic Roof Vent Garnish
- Q&A: Replacement for Coleman Mach 15 With Heat Pump
- Q&A: Garnish for Ventline V2094 RV Roof Vent
- Q&A: Replacement Garnish Trim For A Ventline VD0433 RV Roof Vent
- Q&A: How Does the Alpha Systems Superflex RV Roof Membrane Ship?
- Q&A: Replacement Part For Ventline Manual Roof Vents P/N VDO 433 & VDO 434
- Q&A: What Breakaways Does The Fastway Zip Coiled Trailer Breakaway Cable w/ Plunger Pin Work With?
- Article: How to Replace or Install an RV Roof Vent
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Flat Towing Package for 2025 Ram 1500
- Article: Converting Your RV Water Heater to Tankless
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: How to Replace an RV Roof Vent Cover
Sam
1/27/2026
Tin snips also work very well!