Is Progressive Dynamics 9300 Series RV Converter Charger PD79RR The Same As P9360

Question

Question:

Progressive Dynamics 9300 Series RV Converter Charger - 12V - 60A Your product number shows it as pd79rr i thought it is p9360 from power dynamics. Is it the same product

asked by: Scott C

0

Expert Reply:

Hi Scott! The Progressive Dynamics 9300 Series RV Converter Charger # PD79RR is the same as the PD9360V. We have our own internal part numbers but list the PD part number below the description.

Are you replacing on old converter or is this for a new setup?

expert reply by: Robin H

0

Progressive Dynamics 9300 Series
(click to enlarge)

Answer 1

Hey Brian. To convert the WFCO WF-8955PEC to be lithium compatible you'll need the Progressive Dynamics Replacement Section for AC/DC Power Distribution Panel item #PD4655V. This converter section is specifically designed to replace yours. It…

view full answer...

Answer 2

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

view full answer...

Answer 3

Hey Kyler, thanks for reaching out! **UPDATE IN COMMENT SECTION - JUMPER LOCATION IS DETERMINING FACTOR** The Progressive Dynamics Replacement Section #PD4655V is compatible with lithium batteries. There is a button on the board (see photo) that…

view full answer...

Answer 4

Hello Victor, thanks for reaching out. The Progressive Dynamics 9300 Series RV Converter Charger #PD79RR will work great for replacing your WFCO WF-9855 converter. We recommend this model as a replacement quite frequently in fact, since it has the…

view full answer...

Answer 5

You do not need to have a DC-to-DC charger like the Redarc #331-BCDC1225D installed in your trailer to use the Lithium Battery #GP99QR you have. You can hook the battery directly to the 12v power circuit of your tow vehicle, but this will not charge…

view full answer...

Answer 6

To change the battery mode on the Progressive Dynamics 9300 Series RV Converter Charger #PD79RR you'll need to insert the included CLAW tool into the small opening next to the battery type indicator light. Press and hold that button (using the…

view full answer...

Answer 7

Your older PD9145C charger delivers 45 amps of DC charging power at 13.6 volts DC. (For AGM batteries) This converter/charger requires 725 watts of AC power to operate. It also needs to be on its own AC circuit. The Progressive Dynamics #PD79RR…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Is Progressive Dynamics 9300 Series RV Converter Charger PD79RR The Same As P9360

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching