Is There Height Adjustability with Plowser Hitch Plow

Question

Question:

Does it have any height adjustments at all once you have it in the hitch and set up the bar?

asked by: Dave

0

Expert Reply:

Hey Dave, the Plowswer plow part # PL53YR does not have any height adjustability but as long as you install it in a hitch that is between 11 and 19 inches from the ground it's going to work great.

expert reply by: Jameson C

0

Plowser
(click to enlarge)

Jameson C.

2/10/2026

Hey Dave, how did the Plowser plow work once you had it mounted in your hitch? Knowing how it performed at your hitch height could help others figure out if it’s the right fit for their setup.

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 5

Hey Gregory, that's really good information. You’ve got a few options, but I wouldn’t jump straight to replacing the leaf springs on a half-ton for that size trailer. Since you’re using a Curt weight distribution hitch, that should be doing most…

view full answer...

Answer 6

Hey Don, thanks for the information! That's a significant amount of sag and a pretty heavy trailer, I recommend the Hellwig Pro Series Helper Springs item #HE79FR for the higher 2,500 lbs capacity. I doubt you're driving around with your bed…

view full answer...

Answer 7

Hey Douglas, whenever available I recommend going with the HD version of the Roadactive kits like the part #RAS3611-YHD that fits your 2022 Ford F-150 4WD. The extra capacity of this kit over the non-HD basically doesn't have any downside aside…

view full answer...

Answer 8

Hey Dennis! I can't say if it will clear for sure but I can give you dimensions to help determine if it will. Using the furthest hitch pin hole, the Malone 2" Dual Purpose Hitch Receiver #MPG544 will push the bike rack out 12-1/4". When…

view full answer...

Answer 9

Hey Joe. To charge your F-150's battery while flat towing, you'll need to add a battery charge line kit item #RM-156-25. It's going to connect directly to your truck's battery and has a 15 amp circuit breaker included. You'll wire…

view full answer...

Answer 10

Hi Stan! The SnowBear Snowplow for 2" Hitches - 82" Wide x 19" Tall #K2AVAL8219 and Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2" #C31018 will definitely work on your 2013 Ford F-250 4x4. We actually have both of these…

view full answer...

Answer 11

Hey Gary. The Draw-Tite Front Hitch item #65031 is going to mount a bit higher on your 2004 Toyota Tundra compared to the Curt item #31180. The Curt Front Hitch item #31180 is 14-3/4" off the ground when measured from the top of the inside of…

view full answer...

Is There Height Adjustability with Plowser Hitch Plow

Product Page this Question was Asked From

Continue Researching