Can Valterra StayPut Small Jack Pad be Stacked

Question

Question:

How thick are these? Can you use these while stacked? Can you stack more than 4?

asked by: Ed

0

Expert Reply:

Hey Ed, each of the Valterra Stay Put pads are 3/4 inches thick and they can be used when stacked. You can stack more than 4 if you like as well.

expert reply by: Jameson C

0

Jameson C.

9/29/2025

Hey Ed, did you get a chance to stack the Valterra pads as you planned? I'd love to hear how it worked out for you, as it could give others confidence when stacking them for their needs.

Reply

Answer 1

The TorkLift StableLoad Suspension Upgrade part #TLA7310S and SumoSprings Rebel Custom Helper Springs part #SSR-128-40-2 are both great options for a 2021 Ford F-250 that will help to reduce sag/squat while towing or hauling. They will both work…

view full answer...

Answer 2

Hey Derek, great question and thanks for stopping by! So mainly between the yellow #SSR-127-54 and the black #SSR-127-47 SumoSpring Solo's is the capacity. The yellow's are going to be for a heavier load application with a 2,800 lb capacity,…

view full answer...

Answer 3

Hey David, I reached out to TorkLift for confirmation since our websites show different information. The parts that you need for your vehicle are the front tie does #TL77CR and the rear tie downs #TLF3008. Those are the correct fit for your vehicle,…

view full answer...

Answer 4

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 7

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 11

Hello Jeff, Sounds like you’ve got a big camper (about 4,000 lbs) on your 2024 F-350 dually, and when it’s loaded, the truck feels bouncy and sways a bit. That’s pretty common with heavy campers, especially if the suspension is still stock.…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Can Valterra StayPut Small Jack Pad be Stacked

Product Page this Question was Asked From

Continue Researching