Can Furrion Thermostat Be Left On Dry Setting
Updated 09/26/2025 | Published 04/20/2025
Question:
Is it OK to leave my Furon AC setting on dry? I’m concerned because I set the thermostat to 75 but when I go into the trailer, it is 60° on dry. What’s the best setting for a Furon thermostat so that it doesn’t get that cold in there but I also don’t wanna run up my power bill when we’re not using it.
asked by: Linda N
Expert Reply:
Hi Linda, you can run it on dry. When it is on dry mode the compressor runs continuously when the temperature is higher than the set point. The compressor will cycle on for 10 minutes and off for 6 minutes when the room temp is lower than the set point. The fan speed runs continuously at low speed when it is on dry mode. I would say if you want to keep some air flow and keep power down fan mode on low is the best bet.
(click to enlarge)
Product Page this Question was Asked From
Replacement Premium Wall Thermostat for Furrion Chill HE RV Air Conditioner - Single Zone - Black
- Accessories and Parts
- RV Air Conditioners
- Thermostat
- Furrion
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does The Furrion Chill Cube RV Air Conditioner Come With Hardware and a Seal
- Q&A: What Does Dry Setting on Furrion RV AC Unit Do
- Shop: Towing Mirrors
- Q&A: Wiring Diagram for the Dometic Replacement Single Zone Thermostat
- Shop: K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side
- Search Results: clip~on mirror towing mirrors
- Video: DIY Install: K-Source Snap & Zap Custom Towing Mirrors on your 2014 GMC Sierra 1500
- Video: How to Install the CIPA Custom Towing Mirrors on a 2015 GMC Sierra 1500
- Shop: CIPA Custom Towing Mirrors - Slip On - Driver Side and Passenger Side
- Search Results: rv running lights
- Search Results: front runner led strip lights
- Video: Review of Optronics Trailer Lights - Clearance Lights - OPT73KB
- Video: Let’s Check Out the LED Bullet Clearance or Side Marker Trailer Light with Grommet
- Shop: Optronics LED Trailer Light w/ Grommet - Marker and Clearance Light - Round - Amber
- Shop: LED Bullet Clearance or Side Marker Trailer Light with Grommet - 3 Diodes - Amber Lens
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Video: Towing Mirror Options - Custom Fit VS Universal Fit
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Search Results: trailer wiring
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer jack
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
on Accessories and Parts
Robin H.
9/26/2025
Hi Linda, did you try using the fan mode on low to keep the temperature comfortable without running up your power bill? I'm asking because your experience could help others looking for the best settings on their Furrion thermostat.