Replacement Winch Control Box for DK2 Avalanche

Question

Question:

My DK avalanche 8422 has a 4 pin controller. will this work with the K2WCB?

asked by: Pat A

0

Expert Reply:

Hey Pat, yes the controller part # K2WCB that you referenced does work on your DK2 Avalanche 8422 as we have confirmed this with Detail.

expert reply by: Jameson C

0

Jameson C.

12/22/2025

Hey Pat, how did the K2WCB controller end up working with your DK2 Avalanche 8422? Knowing how it performed could help others looking to match the same setup.

Answer 1

Although the hitches look very similar, the #31109 is for the 2nd gen 2008 Silverado like your friend's, and the #31108 if a fit for the 1st gen, like your 2002 model. The two hitches are very similar, but the #31109 would sit 2 inches lower on…

view full answer...

Answer 2

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 3

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hey Rick, the part #e25ZV was not designed to be used with a trailer towing setup. Especially weight distribution as it adds quite a bit more strain on the setup. If you need more length from a weight distribution setup it's best to go with a…

view full answer...

Answer 6

The Curt Trailer Hitch Receiver part #C15312 is what I recommend as a replacement for the factory trailer hitch on a 2002 Chevrolet Silverado 2500HD. In regards to the bolt hole spacing, this will be a different for the Curt Trailer Hitch Receiver as…

view full answer...

Answer 7

Hi Patrick! The Hellwig Big Wig Rear Anti-Sway Bar #HE94MR is designed for the stock suspension height on your 2002 Chevy Silverado 2500HD. With your truck lowered 2"-4", the main concern will be the end link geometry since lowering changes…

view full answer...

Answer 8

RBW hitches will typically have the same footprint as a Reese hitch so you'll want to verify the connection point spacing to ensure it would fit a standard ISR rail kit. I've attached a diagram below showing the spacing of the rails. For a…

view full answer...

Answer 9

Hi Jeff; there is no maximum tongue weight rating on the etrailer High-Low Fixed Adapter #e25ZV. The adapter is only designed for flat towing, not a trailer or hitch accessory, so it was not tested or given a rating. Are you wanting to use this for…

view full answer...

Answer 10

Hey Dean, the Detail K2 Elite Snowplow part #K2AVAL8219ELT that you referenced comes with all of the electrical components it will need to install. It wires to the vehicle battery as well as comes with a wired switch that you would run to the cab of…

view full answer...

Replacement Winch Control Box for DK2 Avalanche

Product Page this Question was Asked From

Continue Researching