Replacement Marker Lights for Bargman 552 on 1989 Pacer Arrow RV

Question

Question:

i have a 1989 pacer arrow rv that has some marker lights that were taken out by hail and I need to replace them...the lights that are on there now are bargman-52-552-sae-p-p168...any ideas on a comparable replacement?

asked by: James B

0

Expert Reply:

Hello James; the Bargman 552 lights you have are no longer around but we do have a similar replacement. The closest match comes from Optronics and measures 4" long x 2-1/16" tall. You can choose from the following based on LED or incandescent and color:

-Optronics LED Clearance or Side Marker Light w/ Reflex Reflector - Red Lens # MCL31RB

-Optronics Trailer Clearance or Side Marker Light w/ Reflector - Incandescent - Red Lens # MC31RB

-Optronics LED Clearance or Side Marker Light w/ Reflex Reflector - Amber Lens # MCL31AB

-Optronics Trailer Clearance or Side Marker Light w/ Reflector - Incandescent - Amber Lens # MC31AB

expert reply by: Robin H

0

Robin H.

12/22/2025

Hey James, how did the Optronics lights work out as replacements on your Pacer Arrow? It’d be great to hear if the fit and look matched what you were hoping for. Your update could make it easier for others replacing older Bargman lights.

James B.

12/22/2025

@RobinH wasnt able to get them to function as of yet. It could be a wiring issue on my end.

Answer 1

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 2

Your Magnetek 950 is a much older 50 amp converter. The Progressive Dynamics part #PD9260C that you referenced would be a great replacement with a slightly higher amperage rating of 60 amps.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Replacement Marker Lights for Bargman 552 on 1989 Pacer Arrow RV

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching