How to Make 90 Degree Turns With Taylor Made Sealing Foam
Updated 01/27/2026 | Published 08/18/2024
Question:
Hi. How do you make the 90 turns of a square without cutting the sealing foam?
asked by: Kevin G
0
Expert Reply:
HI Kevin; to make a true 90º turn with the # 3691726 you're going to have to cut it. If you don't want to completely cut through the seal at a 45º angle and join the two pieces together you can notch out some triangles that will allow you to make the turn and keep it all in one piece. I recommend looking up some tutorials before you attempt that.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Taylor Made Sealing Foam for Boat Hatch Frames - 8' Long x 3/4" Wide
- Boat Accessories
- Hatch Parts
- Installation Foam
- Black
- Taylor Made
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Taylor Made Sealing Foam for Boat Hatch Frames Feature Review
- Shop: Taylor Made PVC Sealing Foam for Boat Windshields - 6' Long x 3/4" Wide
- Shop: Taylor Made Sealing Foam for Boat Hatch Frames - 8' Long x 3/4" Wide
- Q&A: Recommended Gap Filler For A Vehicle Tail Light
- Search Results: brake away kit
- Q&A: What is the Metal Covered Tank in the rear of an RV of the Roadmaster BrakeMaster
- Q&A: Replacement Klauber Slide Out Motor A-300 K01336A300 for RV
- Q&A: What Gauge Wire Does Opti-Brite 12V LED RV Dome Light # ILL07COB Have
- Q&A: Can The Tray Be Removed From A MORryde RV Cargo Sliding Tray
- Q&A: Do I Need to Trim to Install a Hitch on a 2024/2025 Chevrolet Equinox EV?
Robin H.
1/27/2026
Hey Kevin, how did your 90º turns go with the sealing foam around your hatch frame? Did notching the triangles help you keep it in one piece? Your results could really help others trying to make the same kind of corner.