How is the 4-Way Accessed of Curt Trailer Wiring When Installed on a 2005 Chevy Equinox
Published 05/16/2014 >
Question:
I hooked it up but how do I get the wires outside the vehicle? Do I just hang it out the back and shut the door on it? theres no more directions on this and its not really mentioned anywhere. Thanks, Chevy Equinox 2005
asked by: Dean S
Expert Reply:
Yes, to use the 4-way of the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C55560 on your 2006 Chevy Equinox you will open your rear cargo door, pull the 4-way out, and then shut the door on the wires. Don't worry, the wires will not get pinched or damaged.
An advantage to storing in the vehicle when not in use is that it stays protected from the elements and weather while not in use.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: Hopkins Fold-Over Mounting Bracket for 4-Way Flat Trailer Connector: The Breakdown
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Troubleshooting Trailer Wiring on a 2005 Chevy Equinox that Doesn't work With Trailer but Has Power
- Shop: Roof Rack
- Shop: Curt Mounting Bracket for 4-Pole Flat Trailer Connector
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: No-Drill Mount for Electrical Mounting Bracket - Short
- Shop: Mounting Bracket 4-Pole Flat
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: Why Would Trailer Hitch Install Hardware be Hard to Thread into Vehicle Weld Nut
- Q&A: Solution for Trailer Hitch Install Bolts that Seem too Big to Thread In
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: How to Make a 6-Way Square to 4-Way Flat Trailer Wiring Adapter
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)

