Replacement Hardware Kit Recommendation for a Curt Trailer Hitch # 13535

Question

Question:

Is it possible to order just the hardware kit for Curt Trailer Hitch, # 13535. I have taken mine off due to rust and I am re painting it nd would like to replace the hardware while putting it back.

asked by: Bobby

0

Expert Reply:

Yes, what you will need to do is go to the product page for the Hardware Kit part # RHK, enter the part number of the hitch you have (13535), select Curt as the hitch manufacturer and then hit add to cart and we will ship you a replacement hardware kit.

expert reply by: Jameson C

0

Answer 1

The simplest and most economical option is going to be the Hollywood Racks SR1 2-Bike Carrier #HRSR1. This does mount on the spare tire but the arms which hold the bike can be slide to the side allowing you to better center the bikes behind your 2004…

view full answer...

Answer 2

For just a hitch for your 2008 Honda Pilot all you would need is the Curt #13328 which comes with everything you'd need to install. You might be asking if this comes with trailer wiring, which it does not, so if you needed that as well you'd…

view full answer...

Answer 3

Thank you for your insight, Alan! I 100% agree with you that the whole feeding bolts through the frame and lifting the hitch in place can be super tricky and it's easy to lose bolts inside the frame. The only real issue with going with smaller…

view full answer...

Answer 4

There are 3 hitches made for the 2003 Honda CRV. They each are designed differently and they each have different hardware kits. There are three Class III hitches, the Draw-Tite #75690, the Curt #13535, and the etrailer Hitch #e69AR. You can order the…

view full answer...

Answer 5

A trailer hitch receiver such as the Curt Trailer Hitch Receiver part #13535 which is a confirmed fit for your 2005 Honda CR-V is almost always going to be rated higher than the vehicle's towing capacity. You will need to abide by the lower of…

view full answer...

Answer 6

The Curt hitch part #C13200 has been confirmed as a fit for your 2016 Toyota Highlander and would be an excellent option. It will allow you to keep the full-size spare, but since the tube of the hitch covers a portion of the tire (see picture), you…

view full answer...

Answer 7

Judging by our install pictures it looks like the Draw-Tite part #75690 looks to hang the lowest of all of the hitches we carry that are confirmed to fit your 2006 Honda CR-V. It's not a huge difference, but if you check out the picture I…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Replacement Hardware Kit Recommendation for a Curt Trailer Hitch # 13535

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching