Do etrailer Leaf Springs Come with U-Bolts

Question

Question:

Do these springs come with u bolts?

asked by: Addison

0

Expert Reply:

Hey Addison, the trailer hitch replacement leaf springs part # e44SR does not come with u-bolts. We have U-bolt kits that would work though like with the part # APUBR-9.

expert reply by: Jameson C

0

Answer 1

The 4-Leaf Double-Eye Spring part #e44SR is what I recommend using to replace your Dexter Leaf Spring 072-078-00. It's the same length but a slightly higher capacity, 4,400 lbs vs. 5,000 lbs which is not much so it won't really affect the…

view full answer...

Answer 2

Thank you for the photo! I was able to use the serial number on your axle to determine which is the correct replacement leaf spring for your trailer. For this, you are going to want to use the 3-Leaf Double-Eye Spring #e57SR. The measurement you…

view full answer...

Answer 3

Thank you for all of the information! For your application we have the MORryde 10" Shock Absorbing Equalizers for Tandem Axle Trailers w/ 42" Wheelbase #MR54AR which will fit like a glove for your setup. This system can handle up to 8,000…

view full answer...

Answer 4

It sounds like you have the 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles - 25-1/8" Long #e54SR on your 2019 Keystone Bullet. I recommend relieving the weight off the suspension to see if the springs return to normal heights. I have…

view full answer...

Answer 5

I have included a picture below as measurements for slipper leaf springs are different than double eye leaf springs. A=Eye center to Spring Pin length B=Eye center to end of spring C=Eye center to spring pin center following spring D=Spring pin…

view full answer...

Answer 6

Thanks for the picture and all of the information! Those dimensions do not match up to a leaf spring we currently have but I do have a close option which I think will work. When leaf springs are measured for replacement we ask people to jack the…

view full answer...

Answer 7

It's okay to replace leaf springs with ones rated for more weight and pretty common to do so but keep in mind, the higher you go the rougher the ride will be. If you have a utility trailer then I'd probably opt for the higher rated 5,000 lb…

view full answer...

Answer 8

Hey Jim, thanks for reaching out! Your 2019 Keystone Cougar 32BHS has a GVWR of 11,500 lbs so you should have 5,200 lb axles on your trailer. Something like the 25-1/4" Long 4-Leaf Double-Eye Spring #DX45CR could work but I'll need you to…

view full answer...

Answer 9

Despite what the manufacturers of these equalizers say, the axle/wheel spacing isn't the right way to figure out the best fit for upgraded equalizers, including the MORryde CRE3000. The wheel spacing is more of a guideline, so to determine the…

view full answer...

Answer 10

We can help you out, but there isn't a specific list of parts or way for us to know the measurement of your original leaf springs. That said, what happens over time is that double-eye leaf springs elongate, or stretch out, on a trailer. So to…

view full answer...

Answer 11

The actual weight of the load isn't important when determining what springs you'll need- you will actually need to go by the axle capacity paired with the type of spring and its's length. For your 5000-lb axle, your single spring capacity…

view full answer...

Answer 12

Installing the U-bolts and plate like that would be fine, but I would recommend putting the plate on the leaf springs and running the U-bolts around the axle instead. The good news is you're replacing them so you can make that change when you…

view full answer...

Do etrailer Leaf Springs Come with U-Bolts

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching