Replacement Step Wet Bolt for 1-3/4" Double Eye Springs Suspensions
Updated 09/17/2026 | Published 05/30/2026
Products Featured in This Question
Question:
I have a 2019 Grand design 312bhts travel trailer. I need to replace one of the wet bolts, which part numbers are compatible with my suspension?
asked by: Eric Z
Expert Reply:
Thanks for the information Eric! To replace a single wet bolt in your 2019 Grand Design Reflection 312BHTS suspension you'll need the Step Wet Bolt for 1-3/4" Double Eye Springs item # 34007-187-00. This is an exact replacement for the step bolt that came with the Dexter suspension on your travel trailer.
There is not a specific torque setting for suspension bolts, like item # 34007-187-00. All you have to do is tighten the bolt until the knurled portion of the bolt pulls completely into the shackle strap and the bolt head is ran all the way down to the shackle strap.
You'll also need the Replacement Flange Nut for Dexter Trailer Suspension Kits item # 006-092-01. The nuts and bolts are only meant to be tightened down once so you'll want to replace both.
What happened to your suspension bolt?
You can add this information, along with any other questions you have, where it says Add Comment.
(click to enlarge)
Product Page this Question was Asked From
Step Wet Bolt for 1-3/4" Double Eye Springs
- Trailer Suspension Parts
- Suspension Bolts
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- 9/16 Inch Diameter
- 3-5/8 Inch Long
- Redline
more information >
Continue Researching
- Search Results: maxxair 4951
- Search Results: attic vent
- Search Results: roof vent
- Search Results: butyl tape
- Search Results: maxxair vent
- Search Results: alpha 1021
- Search Results: drip rail
- Shop: Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Shop: Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid
- Shop: Ventline Roof Vent w/ 120V Fan - Manual Lift - 14-1/4" x 14-1/4" - White - Polar Trim
- Shop: Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - White - Birch Trim
- Video: Alpha Systems 8011 Adhesive for RV Roofs Spec Review
- Shop: Alpha Systems Superflex RV Roof Membrane with Installation Kit - Beige - 35' x 9-1/2'
- Shop: Ventline Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - 14-1/4" - White - Birch Trim
- Shop: Alpha Systems Superflex RV Roof Membrane with Installation Kit - White - 35' x 9-1/2'
- Article: Trailer Wiring Diagrams
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Clean Up Your Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Shop: Suspension Enhancement
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Video: Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent Spec Review
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Shop: Brake Controller
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Can Furrion Chill Cube Operate With RV Furnace
on Trailer Suspension Parts
Eric Z.
9/15/2026
Upon replacement I found that the plastic bushing needs replaced as well. What is the part number for that?