Solution for Needing Replacement Switches for Lippert Electric Jack part # LC285318

Question

Question:

Lippert Electric Trailer Jack with Footplate - A-Frame - 18 Lift - 3,500 lbs - Black Item LC285318 Looking for just the 2 swtiches inside this jack. Do you carry those?

asked by: Mike

0

Expert Reply:

Hey Mike, so the only way to get the two replacement switches you are in need of for the Lippert jack part # LC285318 is with the replacement lid that includes the switches which is part # LC285160.

expert reply by: Jameson C

0

Mike

4/18/2024

Thank you

Reply

Answer 1

You are correct that the Lippert Stabilizer no. 1917771 is no longer made. For a replacement, I suggest model #LC298707 which offers faster operation and I believe a lighter weight. This single-motor unit extends up to 30-inches and I believe it will…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hi Mark; the only jack like that is the Lippert Power Stance Electric Trailer Jack #LC89VR but it exceeds the amount you're looking to spend. If you're fine with one that only runs off of the 7-way then I recommend the etrailer Electric…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Uriah, thanks for reaching out! The Tradesman Vaquero Self-Contained Hydraulic A-Frame Trailer Jack #ST86FR will work best if it's hardwired to a battery on your trailer, but you can also hardwire a 7-Way plug and lead like part #H20043 and…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Katja, the Curt Echo Mobile brake controller part #C51180 would be your best option. This is a wireless brake controller and all it requires is a 7-way with the taillight functions and the 12 volt accessory circuit active and you'd be set. So…

view full answer...

Answer 9

Hey Chuck, usually this is a shock problem with surge actuators. The shock isn't allowing the coupler inner member to go all the way forward and release the hydraulic pressure. We have replacement shocks but I would need to know which actuator…

view full answer...

Answer 10

Hey Jay! You do not need to completely reset the air in the air bag when you remove the #SHK23VR. However, you will have to reduce the air pressure slightly so it isn't clamped on tight. All you have to do is push in on the air valve and the…

view full answer...

Solution for Needing Replacement Switches for Lippert Electric Jack part # LC285318

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching