Can Round U-Bolts Be Used On a Square Axle Tube?

Question

Question:

Is it safe to use round U-bolts on a square trailer axle?

asked by: Shawn A

0

Expert Reply:

You need to use square U-Bolts with having a square axle tube. Trying to use round U-Bolts you risk damaging both the bolts and the axle as it creates pressure points rather than distributing the load across the surface. We have a few different size bolts you can see in the list below.

1-1/2" U-Bolts # SP01-120
1-3/4" U-Bolt # 175130
2" U-Bolts # SP01-160

expert reply by: Bud M

0

Answer 1

Thank you for the photos, though there is only one measurement there so it would be very difficult for me to tell you exactly what you currently have. That said, the most important measurement you can take is of your brake mounting flange, and I…

view full answer...

Answer 2

Hi Todd, To go with trailer leaf springs that are slightly stiffer than the 4,400 lb rating of your axle you can go with 4,500 lb springs or 5,000 lb springs. The right one is going to depend on the length of your current springs though, as…

view full answer...

Answer 3

There are no U-bolts to attach the slipper part, I recommend replacing your slipper springs with double eye springs. In order to do this you need to know the weight rating of your axle as well as the length from center eye to center eye so you can…

view full answer...

Answer 4

When choosing the correct replacement leaf spring for your trailer you will first need to remove the old leaf spring that you currently have on your trailer and measure the unloaded length as well as the construction of the spring (double eye or…

view full answer...

Answer 5

The F78/15 stated in modern tire size terms would be a 205/75-15. When you need replacement tires, I'd recommend going with a radial tire because radials do a better job of shedding heat. Excessive heat build-up is the number one cause of…

view full answer...

Answer 6

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 7

Good morning Tim! The RV Designer Hitch Pin - 1/2" - Qty 1 #RD83GR measures a little over 3" from the clip hole to the edge of the straight part, just where it starts to bend. So that measurement is the span, and that tells us it'll…

view full answer...

Answer 8

We currently have two shackle straps that will fit the CE Smith U-Bolt part #CE15502A. For this you can choose from the Shackle Strap part #TRSL313 or part #115208GALV. Both of these shackle straps have a bolt hole to bolt hole measurement of…

view full answer...

Answer 9

It's not uncommon for new trailer leaf springs to measure shorter than the old leaf springs they are replacing. The reason for this is that leaf springs stretch as they age. Therefore, I do think the 26" long leaf spring options we offer…

view full answer...

Answer 10

Hello Russ, Welcome to etrailer, I'm glad you found us! Yes, those parts are compatible with each other for a 2" square 3,500 lb axle. The U-Bolt Plate #117594 is specifically designed for a 2" square axle with 1-3/4" or 2"…

view full answer...

Answer 11

You can replace your surge brake actuator on your boat trailer with the Hydrapro Alpha G-1600X Electric Over Hydraulic Actuator #DH44FR. You can either replace your coupler or lock it out to save some money. You will also need to add a 7-way #H20043,…

view full answer...

Can Round U-Bolts Be Used On a Square Axle Tube?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching