What Circuits Should 3rd Brake Light Module PP20-702 Wire To
Updated 02/20/2024 | Published 02/19/2024
Question:
I recently purchased the Pacer Performance 3rd Brake Light Logic Module Stock # 20-702 from etrailer. Part was purchased to enable 3rd brake light installation on topper on 2019 Nissan Frontier with tow package. Wanted to activate the light through the trailer lights hook up. Used a 7way to 4 way adapter first then wired the left turn/stop and right turn/stop to yellow wires from module. Wired geen module wire to red brake light wire and wired black light wire to pigtail white ground wire. Brake works fine but light still blinks with right and left turn signal. Checked all connections. Module didnt appear to filter the blinkers. Any help would be appreciated. Thank you- Sue
asked by: Sue
Expert Reply:
Hey Sue, so the wiring colors you mentioned don't match what the part # PP20-702 have so I am not sure what's going on. This is supposed to have two yellow wires that you run to both stop turn circuits and then the green runs to the isolated brake light circuit.
I would also check to make sure the wire colors you ran to on the trailer wiring are the correct stop/turn circuits as well.
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Shop: 3rd Brake Light Logic Module
- Video: Complete Breakdown of the 3rd Brake Light Logic Module
- Shop: Vehicle Tow Bar Wiring
- Shop: Loadstar ST225/75D15 Bias Trailer Tire with 15" White Wheel - 6 on 5-1/2 - Load Range D
- Shop: Kenda Karrier KR53 ST225/75R15 Radial Trailer Tire with 15" Galvanized Spoke Wheel - 6 on 5-1/2
- Shop: Kenda Karrier KR53 ST225/75R15 LR D Radial Trailer Tire w/ 15" Aluminum AM06 Wheel - 6 on 5-1/2
- Q&A: How Would Dedicated Third Brake Light Get Wired on Trailer
- Q&A: How to Wire a Third Brake Light on Trailer
- Q&A: Comparing the Converters To Use for a Third Brake Light On a Trailer
- Q&A: 3rd Brake Light Module for a 2024 Chevrolet Silverado 1500
- Q&A: Powering 3rd Brake Light and Dome Light on Topper for 2025 Silverado 1500
- Q&A: How To Wire In A Camper Shell Third Brake Light On A 2021 GMC Sierra
- Q&A: How to Add a Third Brake Light to a Trailer
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Shop: Trailer Wiring
- Shop: Hook Probe Circuit Tester
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Search Results: trailer tires and wheels
- Shop: Suspension Enhancement
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Search Results: trailer jack
on Accessories and Parts
Sue
2/19/2024
Sorry I didn't explain well - It is wired Just as you described. I said "wired the left turn/stop and right turn/stop to yellow wires from module and Wired geen module wire to red brake light wire". Brake light stop light works but light is also blinking when turn signals are activated.