How do Trailer Lights with a Single Wire Install
Published 11/08/2023
Question:
I bought Kenway Led replacement clearance lights. They only have one wire, my current lights have 2 wires. How do I install these? Thank you
asked by: Patrick B
0
Expert Reply:
Trailer lights that have a single wire use the mounting hardware as the ground circuit. So basically you just run power to the single wire and it would ground itself. You can also run the previous ground wire to the mounting hardware as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Trailer Clearance or Side Marker Light with Chrome Bezel - 7 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Surface Mount
- Non-Submersible Lights
- LED Light
- 3 Inch Diameter
- Red
- Command Electronics
more information >
Continue Researching
- Q&A: Replacement A-Frame Jack For Atwood Mobile Product Jack On Trailer With 2" Diameter Mounting Hole
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: What Does Working Load Limit Mean for E-Track
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Does Dexter Axle 20545I-EZ-72-15 have a Front and a Back
- Q&A: 13" Trailer Wheel and Tire That is Compatible with the Americana Baby Moon Trailer Wheel Center Cap
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)