Replacement Motor Head For HappiJac Manual to Electric Conversion Kit on #4150 Camper Jacks

Question

Question:

Have HappiJac #4150 jacks on slide in camper. Need a replacement motor? Would you have something? Thanks

asked by: Doh

0

Expert Reply:

Since the HappiJac #4150 jacks were manual jacks you likely had the Conversion Kit # LC733960-182524 installed. If this is what you have you will need the Replacement Motor # LC759927.

expert reply by: Bud M

0

Answer 1

Hello Zach. The TorkLift Tie Downs #TLF2022A and #TLF3008A will work with your 2022 Ford F-350 short bed but the front tie downs will not be compatible with the AMP Research Powered Running Boards as they will get in the way of each other. You would…

view full answer...

Answer 2

The Torklift Tie Downs part #TLF3004 and #TLF2012 are sold as complete kits and do not have replacement parts sold for them. With either kit though you'll be able to use the Fast Guns so you wouldn't be replacing everything that you have…

view full answer...

Answer 3

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 7

Hey Gene, welcome back! The correct tie-downs are the TorkLift Talon item #TL45SV, you were looking at. This a set of front and rear tie-downs. The rear ones will attach directly to your 2025 Ford F-450's TorkLift SuperHitch Magnum hitch item…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Hey Michael, if you check out the attached picture you can see all of the individual components that come with the HappiJac Electric Truck Camper Jack System #LC736515-ELKIT that you referenced. Everything you'd need would come with this as it…

view full answer...

Answer 10

Hello Mel, great question! Yes, the Torklift tie downs part #TL66FV will fit your 2006 GMC Sierra 2500HD crew cab with the 8 foot bed, provided your truck does not have running boards or cab length boards that extend under the bed, and you are not…

view full answer...

Answer 11

If you're looking for just the L-bracket for your HappiJac Electric Truck Camper Jack System #LC736514-ELKIT then you'll need part #LC182492. The flat bracket can be swapped out with part #LC182494 and the swing brackets can be replaced with…

view full answer...

Answer 12

Hey Jack, yes the Torklift camper tie downs part #TL63PR are the correct set for your 2024 Ford F-350 Tremor with a short bed and factory hitch. The turnbuckles part #TLS9526-2 that you referenced as well would be a great set that matches what you…

view full answer...

Replacement Motor Head For HappiJac Manual to Electric Conversion Kit on #4150 Camper Jacks

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching