Parts Needed to Flat Tow a 2023 Ford F-250

Question

Question:

I am looking to flat tow a 2023 Ford F-250. What parts do I need?

asked by: Diane

0

Expert Reply:

To flat tow your 2023 Ford F-250 you will need the following parts:

Tow Bar and Safety Chains - Demco Excali-Bar III Non-Binding Tow Bar item # DM9511013

Base Plate Kit - Demco Classic Base Plate Kit item # DM68FR

Wiring Harness - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit item # RM-15267

Supplemental Braking System - Blue Ox Patriot Radio Frequency, Portable Braking System item # BLU37TR

High Low Adapter - The tow bar needs to be within 3" of level. If you measure the height of the inside top of the hitch receiver tube on your RV, and the height difference is more than 3 inches above/below the base plate tab height, you'll need a high/low adapter. I have linked a FAQ article that explains all this in more detail along with our selection of adapters.

expert reply by: Jerred H

0

Answer 1

Hey John, you can install an AC unit like the Advent Air #ADV95SR on the roof of an enclosed car hauler like you have but you will need to do a little reinforcing of the roof and come up with some framing around the opening for the unit to install.…

view full answer...

Answer 2

If you are not wanting to use a Adapter 7-Pole to 6-Pole #47549 and would rather wire in a new Hopkins 7-Way RV Style Connector #HM20087 the wiring may be confusing. There may be some trial and error involved as the wiring could have been connected…

view full answer...

Answer 3

The Blue Ox Patriot part #BLU37TR will actuate the brakes in a similar way to the Air Force One #SM99243 but the applications are different. The Air Force One is a permanent install system that ties into the air brake system of the tow vehicle to…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Parts Needed to Flat Tow a 2023 Ford F-250

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching